Dynamic Transformation during Simulated Hot Rolling
Authors:
- 1 July 2013
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 762, 1-8
Abstract
High temperature flow curves were evaluated on two Nb steels in both compression and torsion and at a series of temperatures and strain rates. The critical strains for the initiation of dynamic transformation (DT) were determined by the double differentiation method. These are shown to be distinctly lower than those associated with dynamic recrystallization (DRX). It is also evident that the compression critical strains for both DT and DRX are lower than the equivalent torsion critical strains. Mean flow stresses (MFSs) were calculated by integration from the flow curves. When plotted against inverse temperature, stress drops were observed about 30 degrees above the Ae3. These drops are shown to be caused by the dynamic transformation of austenite to ferrite, a softer phase. The characteristics of the ferrite produced dynamically are described and the transformation is shown to be displacive in nature, leading to the appearance fine Widmanstatten plates.Keywords
This publication has 8 references indexed in Scilit:
- The Critical Strain for Dynamic Transformation in Hot Deformed AusteniteISIJ International, 2013
- Transformation of Deformed Austenite at Temperatures above the Ae3 Materials Science Forum, 2012
- Simulation of Austenite Flow Curves under Industrial Rolling Conditions Using a Physical Dynamic Recrystallization ModelISIJ International, 2012
- Dynamic Transformation of a Low Carbon Steel at Temperatures above the Ae3ISIJ International, 2011
- The Ferrite Transformation in Hot Deformed 0.036% Nb Austenite at Temperatures Above the Ae3ISIJ International, 2010
- The effect of stress on the Widmanstätten ferrite transformationMaterials Science and Engineering: A, 1997
- A one-parameter approach to determining the critical conditions for the initiation of dynamic recrystallizationActa Materialia, 1996
- Overview no. 35 Dynamic recrystallization: Mechanical and microstructural considerationsActa Metallurgica, 1984