A Hybrid Strategy for Profile Measurement of Micro Gear Teeth
Open Access
- 2 September 2023
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 14 (9) , 1729
Abstract
A hybrid strategy is proposed to meet the challenge of obtaining the profile of micro gear teeth with a small modulus. Firstly, the contact probe segmentally obtained the falling flank profiles with an auxiliary lifting mechanism to avoid interference when it climbs on the rising slope. Then, the noncontact chromatic confocal displacement sensor efficiently acquired the gear peak positions to carry out the two-point error separation with the gear peak positions from the probe measurement. Finally, actual experiments were carried out to obtain the profile of a harmonic drive flexspline. Compared with the commercial ultraprecise profiler, the proposed method provides measurement results with a deviation of less than 20 μm. In conclusion, the hybrid strategy is feasible and accurate for drawing the micro gear teeth profile without any collision between the measuring probes and the measured workpiece.Keywords
Funding Information
- Interdisciplinary Foundation of Shenzhen International Graduate School, Tsinghua University (JC2021003, 62275142, 62205314, WDZC20200820200655001)
- National Natural Science Foundation of China (JC2021003, 62275142, 62205314, WDZC20200820200655001)
- Natural Science for Youth Foundation of China (JC2021003, 62275142, 62205314, WDZC20200820200655001)
- Shenzhen Stable Supporting Program (JC2021003, 62275142, 62205314, WDZC20200820200655001)
This publication has 27 references indexed in Scilit:
- Solid-state SiO2 nano-gears AFM tip manipulation on HOPGNanotechnology, 2014
- Effect of step number on roundness determination using multi-step methodInternational Journal of Precision Engineering and Manufacturing, 2013
- Review on Multi-Point Method for Roundness Error SeparationAdvanced Materials Research, 2013
- Surface profile measurement of internal micro-structuresInternational Journal of Precision Engineering and Manufacturing, 2013
- Eccentric Error Compensation for Pitch Deviation Measurement of GearsKey Engineering Materials, 2012
- Fabrication of micro-ball styluses for scanning-type surface form metrologyInternational Journal of Nanomanufacturing, 2012
- Surface Form Measurement and Analysis of a Cylindrical Workpiece with MicrostructuresJournal of Advanced Mechanical Design, Systems, and Manufacturing, 2012
- Disturbance-observer-based adaptive feedforward cancellation of torque ripples in harmonic drive systemsElectrical Engineering, 2007
- A note on the three-point method for roundness measurementPrecision Engineering, 2005
- Four-Point Method of Roundness and Spindle Error MeasurementsCIRP Annals, 1993