Permeability enhancement due to microcrack dilatancy in the damage regime
Authors:
- Guy SimpsonGSGuy Simpson
- Yves GuéguenYGYves Guéguen
- Frédéric SchneiderFSFrédéric Schneider
- 10 March 2001
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 106 (B3) , 3999-4016
Abstract
A three dimensional microscopically based permeability model incorporating inelastic deformation has been developed to account for the modification of transport properties due to fracturing. The basic hypothesis investigated is that permeability enhancement during brittle deformation is caused by the formation of dilatant microcracks which are associated with friction sliding on a preexisting random population of shear cracks. Additional dilatancy, produced as a result of frictional sliding over asperities, is also accounted for by the introduction of a crack roughness parameter. Linear elastic fracture mechanics is used to calculate the evolution of crack length and crack area as a function of applied stress and fluid pressure. After making a geometrical simplification the microcrack parameters derived from the deformation model can be used to calculate the permeability tensor assuming that fluid transport results from Poiseuille flow through a connected distribution of cracks. The model enables investigation of the macroscopic permeability variation as a function of two loading parameters, three constant material parameters, and the crack roughness parameter. Results demonstrate that permeability is a smooth but strongly increasing (near power law) function of the Terzaghi effective stress ratio and is strongly dependent on the initial crack density, Young's modulus, the friction coefficient, and the effective confining pressure. Numerical results are in quantitative agreement with published experimental measurements and display behavior similar to results obtained with a relatively simple analytical model. The model enables calculation of the degree of stress‐induced anisotropy, which is shown is be relatively small (< × 10) for resonable effective stress ratios. The modeling presented provides a quantitative tool with which the effects of microcrack‐induced permeability enhancement can be investigated within the broader context of coupled fluid flow and brittle deformation in the crust.Keywords
This publication has 42 references indexed in Scilit:
- Permeability of fault-related rocks, and implications for hydraulic structure of fault zonesJournal of Structural Geology, 1997
- Microstructures, percolation thresholds, and rock physical propertiesTectonophysics, 1997
- The transition from brittle faulting to cataclastic flow: Permeability evolutionJournal of Geophysical Research, 1997
- Structural permeability of fluid-driven fault-fracture meshesJournal of Structural Geology, 1996
- Influence of crystal plastic deformation on dilatancy and permeability development in synthetic salt rockTectonophysics, 1996
- Mechanical and transport properties of crustal rocks: from single cracks to crack statisticsPhysics of the Earth and Planetary Interiors, 1989
- Coupled grain-scale dilatancy and mass transfer during deformation at high fluid pressures: examples from Mount Lyell, TasmaniaJournal of Structural Geology, 1989
- Microcracks in rocks: A reviewTectonophysics, 1983
- Development of stress-induced microcracks in Westerly GraniteInternational Journal of Rock Mechanics and Mining Sciences, 1976
- Post-failure behavior of a granite and diabaseRock Mechanics and Rock Engineering, 1971