Long-Time Behavior of Surface Properties of Microstructures Fabricated by Multiphoton Lithography
Open Access
- 3 December 2021
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 11 (12) , 3285
Abstract
The multiphoton lithography (MPL) technique represents the future of 3D microprinting, enabling the production of complex microscale objects with high precision. Although the MPL fabrication parameters are widely evaluated and discussed, not much attention has been given to the microscopic properties of 3D objects with respect to their surface properties and time-dependent stability. These properties are of crucial importance when it comes to the safe and durable use of these structures in biomedical applications. In this work, we investigate the surface properties of the MPL-produced SZ2080 polymeric microstructures with regard to the physical aging processes during the post-production stage. The influence of aging on the polymeric microstructures was investigated by means of Atomic Force Microscopy (AFM) and X-ray Photoelectron Spectroscopy (XPS). As a result, a time-dependent change in Young’s Modulus, plastic deformation, and adhesion and their correlation to the development in chemical composition of the surface of MPL-microstructures are evaluated. The results presented here are valuable for the application of MPL-fabricated 3D objects in general, but especially in medical technology as they give detailed information of the physical and chemical time-dependent dynamic behavior of MPL-printed surfaces and thus their suitability and performance in biological systems.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (457594480, 232311024)
This publication has 49 references indexed in Scilit:
- Two-photon polymerization-generated and micromolding-replicated 3D scaffolds for peripheral neural tissue engineering applicationsBiofabrication, 2012
- Tailor-made three-dimensional hybrid scaffolds for cell culturesBiomedical Materials, 2011
- Two‐photon stereolithography for realizing ultraprecise three‐dimensional nano/microdevicesLaser & Photonics Reviews, 2009
- Ultra-Low Shrinkage Hybrid Photosensitive Material for Two-Photon Polymerization MicrofabricationACS Nano, 2008
- Nanomechanical Properties of Mechanical Double-Layers: A Novel Semiempirical AnalysisLangmuir, 2007
- Multiphoton polymerizationMaterials Today, 2007
- Force measurements with the atomic force microscope: Technique, interpretation and applicationsSurface Science Reports, 2005
- Polymer microcantilevers fabricated via multiphoton absorption polymerizationApplied Physics Letters, 2005
- Chemically Amplified Positive Resists for Two‐Photon Three‐Dimensional MicrofabricationAdvanced Materials, 2003
- Inkjet Printing for Materials and DevicesChemistry of Materials, 2001