Numerical Prediction of Turbulent Flow and Heat Transfer Enhancement in a Square Passage With Various Truncated Ribs on One Wall
- 25 October 2013
- journal article
- Published by Wiley in Journal of Heat Transfer
- Vol. 136 (1) , 011902
Abstract
Repeated ribs are often employed in the midsection of internal cooling passages of turbine blades to augment the heat transfer by air flowing through the internal ribbed passages. Though the research of flow structure and augmented heat transfer inside various ribbed passages has been well conducted, previous works mostly paid much attention to the influence of rib topology (height-to-pitch, blockage ratio, skew angle, rib shape). The possible problem involved in the usage of ribs (especially with larger blockage ratios) is pressure loss penalty. Thus, in this case, the design of truncated ribs whose length is less than the passage width might fit the specific cooling requirements when pressure loss is critically considered. A numerical study of truncated ribs on turbulent flow and heat transfer inside a passage of a gas turbine blade is performed when the inlet Reynolds number ranges from 8000 to 24,000. Different truncation ratio (truncated-length to passage-width) rib geometries are designed and then the effect of truncation ratio on the pressure drop and heat transfer enhancement is observed under the condition of constant total length. The overall performance characteristics of various truncated rib passages are also compared. It is found that the heated face with a rib that is truncated 12% in length in the center (case A) has the highest heat transfer coefficient, while the heated face with a rib that is truncated 4% at three locations over its length, in the center and two sides (case D), has a reduced pressure loss compared with passages of other designs and provides the lowest friction factors. Although case A shows larger heat transfer augmentation, case D can be promisingly used to augment side-wall heat transfer when the pressure loss is considered and the Reynolds number is relatively large.Keywords
This publication has 19 references indexed in Scilit:
- Effect of Rib Spacing on Heat Transfer in a Two Pass Rectangular Channel (AR = 2:1) at High Rotation NumbersJournal of Heat Transfer, 2012
- Heat Transfer and Pressure Drop Correlations for Square Channels With V-Shaped Ribs at High Reynolds NumbersJournal of Heat Transfer, 2011
- High Rotation Number Effect on Heat Transfer in a Triangular Channel With 45 deg, Inverted 45 deg, and 90 deg RibsJournal of Heat Transfer, 2010
- On Prediction of Thermal-Hydraulic Characteristics of Square-Sectioned Ribbed Cooling DuctsJournal of Turbomachinery, 2001
- A Numerical Study of Flow and Heat Transfer in a Smooth and Ribbed U-Duct With and Without RotationJournal of Heat Transfer, 2000
- Recent progress in the computation of flow and heat transfer in internal cooling passages of turbine bladesInternational Journal of Heat and Fluid Flow, 1999
- Computation of flow and heat transfer through rotating ribbed passagesInternational Journal of Heat and Fluid Flow, 1998
- Heat Transfer and Friction in Rectangular Channels With Ribbed or Ribbed-Grooved WallsJournal of Heat Transfer, 1994
- Effect of ridge shapes on turbulent heat transfer and friction in a rectangular channelInternational Journal of Heat and Mass Transfer, 1993
- Developing heat transfer in rectangular channels with rib turbulatorsInternational Journal of Heat and Mass Transfer, 1988