Combined vibration and thermal analysis for the condition monitoring of rotating machinery
- 26 February 2014
- journal article
- research article
- Published by SAGE Publications in Structural Health Monitoring
- Vol. 13 (3) , 281-295
Abstract
Traditional practice in vibration-based condition monitoring of rotating machines with a multiple bearing system, such as turbo-generator sets, is data intensive. Since a number of sensors are required at each bearing location, the task of diagnosing faults on these systems may be daunting for even an experienced analyst. Hence, this study seeks to develop a simplified fault diagnosis method that uses just a single vibration and a single temperature sensor on each bearing. Experiments were done on a laboratory rig with two dissimilar length rotors supported through four ball bearings. Commonly encountered rotor-related faults were independently simulated and compared to a baseline condition. For reference, conventional vibration spectrum analysis was done first. Overall vibration analysis was then conducted and combined with temperature data in two diagnosis approaches. Learning from the first combined approach, which had some limitations, was used to propose a principal component analysis–based approach that was demonstrated with and without temperature data. Results of the proposed principal component analysis–based method suggest that supplementing vibration data with temperature measurements gives improved fault diagnosis when compared to fault diagnosis using vibration data alone. The experimental rig, measurements done, description of both combined approaches and results obtained are presented in this article.Keywords
This publication has 21 references indexed in Scilit:
- A review on empirical mode decomposition in fault diagnosis of rotating machineryMechanical Systems and Signal Processing, 2013
- A future possibility of vibration based condition monitoring of rotating machinesMechanical Systems and Signal Processing, 2013
- Experimental analysis on fault detection for a direct coupled rotor-bearing systemMeasurement, 2013
- Monitoring of Fatigue Crack Stages in a High Carbon Steel Rotating Shaft Using VibrationProcedia Engineering, 2011
- Identification of unbalance in a rotor bearing systemJournal of Sound and Vibration, 2011
- Experimental investigations on vibration response of misaligned rotorsMechanical Systems and Signal Processing, 2009
- Numerical and experimental investigation of the vibration of rotors with loose discsProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2009
- Experimental response and vibrational characteristics of a slotted rotorCommunications in Nonlinear Science and Numerical Simulation, 2009
- Experimental observation of nonlinear vibrations in a rub-impact rotor systemJournal of Sound and Vibration, 2005
- Vibration analysis of rotors for the identification of shaft misalignment Part 2: Experimental validationProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2004