Investigating the EMI Mitigation in Power Inverters Using Delay Compensation
- 20 July 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (5) , 4270-4278
Abstract
Electromagnetic emissions (EME) of electric and electronic units should comply with national and international standards. Software approaches to reduce the conducted EME are preferable, since they do not require additional on-board hardware. Many techniques have been developed, with different levels of efficiency. This work aims to analyze a new software method to mitigate the conducted emissions of three phase power inverters, focusing on those used to drive brushless DC motors (BLDC). This has been done reducing the conducted EMI common mode (CM) component using software to compensate parasitic delays. The technique is verified both analytically and experimentally, and its performances have been compared to the Spread Spectrum Modulation (SSM) ones. The proposed approach shows better performances with respect to SSM below 24 MHz. The results confirm the effectiveness of the delay compensation technique in terms of CM conducted emissions reduction. Moreover, the proposed approach has no drawbacks on safety and it does not present reductions in the inverter efficiency.Keywords
This publication has 13 references indexed in Scilit:
- Spread Spectrum Technique to Reduce EMI Emission for an LLC Resonant Converter Using a Hybrid Modulation MethodIEEE Transactions on Power Electronics, 2017
- New Method for Common Mode Voltage Cancellation in Motor Drives: Concept, Realization, and Asymmetry InfluenceIEEE Transactions on Power Electronics, 2017
- Software based control of the EMI generated in BLDC motor drives2016
- Reduction of Common Mode Voltage and Conducted EMI Through Three-Phase Inverter TopologyIEEE Transactions on Power Electronics, 2016
- EMI Reduction via Spread Spectrum in DC/DC Converters: State of the Art, Optimization, and TradeoffsIEEE Access, 2015
- Digital Slew Rate and S-Shape Control for Smart Power Switches to Reduce EMI GenerationIEEE Transactions on Power Electronics, 2014
- An Effective Dithering Method for Electromagnetic Interference (EMI) Reduction in Single-Phase DC/AC InvertersIEEE Transactions on Power Electronics, 2013
- Conducted Common-Mode EMI Reduction by Impedance BalancingIEEE Transactions on Power Electronics, 2012
- Custom Spectral Shaping for EMI Reduction in High-Frequency Inverters and BallastsIEEE Transactions on Power Electronics, 2005
- Use of sigma-delta modulation to control EMI from switch-mode power suppliesIEEE Transactions on Industrial Electronics, 2001