Effect of Homogenization Treatment on Superplastic Properties of Aluminum Based Alloy with Minor Zr and Sc Additions
- 20 July 2018
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 385, 84-90
Abstract
Effect of one-step and two-step homogenization treatment on precipitation of Al3(Sc,Zr) dispersoids, grain structure after annealing of cold rolled sheets and superplastic behaviour of a novel Al-Mg based alloy were studied. Heterogeneous nucleation of Al3(Sc,Zr) phase on dislocations and subboundaries dominated at one-step annealing and both homogeneous and heterogeneous nucleation of Al3(Sc,Zr) were observed at two-step annealing modes. It was shown that two-step treatment mode provides high density of Al3(Sc,Zr) precipitates and 650 % of elongation at the constant strain rate of 10-2 s-1 in the studied alloy.Keywords
This publication has 35 references indexed in Scilit:
- Effect of temperature of isothermal multidirectional forging on microstructure development in the Al-Mg alloy with nano-size aluminides of Sc and ZrJournal of Alloys and Compounds, 2018
- Effect of Sc and Zr additions on the microstructure/strength of Al-Cu binary alloysMaterials Science and Engineering: A, 2017
- Synergetic effects of Sc and Zr microalloying and heat treatment on mechanical properties and exfoliation corrosion behavior of Al-Mg-Mn alloysMaterials Science and Engineering: A, 2016
- Role of Zr and Sc addition in controlling the microstructure and tensile properties of aluminum–copper based alloysMaterials & Design, 2015
- Microstructural and texture changes during equal channel angular pressing of an Al–Mg–Sc alloyJournal of Alloys and Compounds, 2015
- Extraordinary high-strain rate superplasticity of severely deformed Al–Mg–Sc–Zr alloyMaterials Science and Engineering: A, 2012
- Effects of homogenization treatment on recrystallization behavior and dispersoid distribution in an Al–Zn–Mg–Sc–Zr alloyJournal of Alloys and Compounds, 2008
- Effect of minor Sc and Zr on microstructure and mechanical properties of Al-Zn-Mg-Cu alloyTransactions of Nonferrous Metals Society of China, 2006
- Scientific principles of making an alloying addition of scandium to aluminium alloysMaterials Science and Engineering: A, 2000
- Aging behavior of Al-4.5%Mg, Al-4.5%Mg-0.35%Mn and Al-1.3%Mg-1.1%Mn alloys containing 0.2%Cu.Journal of Japan Institute of Light Metals, 1992