Pulsed laser deposition of strontium-substituted hydroxyapatite coatings
Authors:
- I. PereiroIPI. Pereiro
- C. Rodríguez-ValenciaCRC. Rodríguez-Valencia
- C. SerraCSC. Serra
- E.L. SollaESE.L. Solla
- J. SerraJSJ. Serra
- P. GonzálezPGP. González
- 1 September 2012
- journal article
- conference paper
- Published by Elsevier in Applied Surface Science
- Vol. 258 (23) , 9192-9197
Abstract
No abstract availableKeywords
This publication has 23 references indexed in Scilit:
- Biomineralized strontium-substituted apatite/titanium dioxide coating on titanium surfacesActa Biomaterialia, 2010
- The structure of strontium-doped hydroxyapatite: an experimental and theoretical studyPhysical Chemistry Chemical Physics, 2008
- Structural analysis of a series of strontium-substituted apatitesActa Biomaterialia, 2008
- Synthesis and thermal stability of potassium substituted hydroxyapatites and hydroxyapatite/β-tricalciumphosphate mixturesCeramics International, 2007
- Strontium ranelate: New insights into its dual mode of actionBone, 2007
- XPS characterization of biocompatible hydroxyapatite–polymer coatingsSurface and Interface Analysis, 2002
- The divalent strontium salt S12911 enhances bone cell replication and bone formation in vitroBone, 1996
- Strontium increases vertebral bone volume in rats at a low dose that does not induce detectable mineralization defectBone, 1996
- Pulsed laser deposition of hydroxylapatite thin films on Ti‐6Al‐4VJournal of Applied Biomaterials, 1992
- Apatite single crystals. Formation, dissolution and influence of CO32− ionsRecueil des Travaux Chimiques des Pays-Bas, 1981