α 2 phase precipitation behavior and tensile properties at room temperature and 650 °C in an (α + β) titanium alloy
Authors:
- 21 October 2019
- journal article
- research article
- Published by Wiley in Rare Metals
- Vol. 40 (11) , 3261-3268
Abstract
The microstructure, room temperature and 650 °C tensile properties of an (α + β) titanium alloy were investigated after aging over a temperature range of 600–750 °C following solution treatment. The results exhibit that both aging temperature and aging time influence the precipitation behavior of α 2 phase, and the size of α 2 phase affects the tensile properties. The growth speed of α 2 phase gets quicker with the aging temperature increasing under the same aging time. For a given aging temperature, the size of α 2 phase gets larger when prolonging the aging time. There are significant improvements in yield and ultimate tensile strength at room temperature and 650 °C after aging at 600 °C for 2 h, but these values decrease with the size of α 2 phase increasing. It is found that α 2 phase, less than 7 nm, does not impair the room‐temperature ductility. However, when the size of α 2 phase grows up from 7 to 15 nm, ductility decreases drastically. During 650 °C tensile process, with the particle size increasing from 3 to 15 nm, the interaction between moving dislocations and coherent particles changes from cutting mechanism to bypass mechanism.Keywords
Funding Information
- National Natural Science Foundation of China (51801177)
This publication has 22 references indexed in Scilit:
- Effect of isothermal forging strain rate on microstructures and mechanical properties of BT25y titanium alloyMaterials Science and Engineering: A, 2016
- The effects of Nb content on microstructure and fracture behavior of near α titanium alloysMaterials & Design (1980-2015), 2015
- Investigation on high temperature short-term creep and stress relaxation of titanium alloyMaterials Science and Engineering: A, 2015
- A Comparative Study on Dwell Fatigue of Ti-6Al-2Sn-4Zr-xMo (x = 2 to 6) Alloys on a Microstructure-Normalized BasisMetallurgical and Materials Transactions A, 2014
- Effect of Zr and Si addition on high temperature mechanical properties of near-α Ti–Al–Zr–Sn based alloysMaterials Science and Engineering: A, 2014
- Tensile behavior at 700°C in Ti–Al–Sn–Zr–Mo–Nb–W–Si alloy with a bi-modal microstructureMaterials Science and Engineering: A, 2014
- Perspectives on Titanium Science and TechnologyActa Materialia, 2013
- The kinetics of dynamic globularization during hot working of a two phase titanium alloy with starting lamellar microstructureMaterials Science and Engineering: A, 2012
- High-temperature Titanium AlloysDefence Science Journal, 2005
- Effect of order in Ti3Al particles and of temperature on the deformation behavior of age-hardened TiAl alloysMaterials Science and Engineering, 1977