Effect of machine compliance on mold deflection during injection and packing of thermoplastic parts
Authors:
- 17 May 2006
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 46 (7) , 844-852
Abstract
Minimizing mold deflection is essential when manufacturing plastic parts to tight tolerances. Both the mold and the machine are compliant and deform upon loading, which can affect the part quality. Therefore, understanding mold deflection during injection molding is critical for determining the final geometry of the part. It is also critical for secondary processes such as the in‐mold coating process. This article presents work in quantifying both mold deflection during an injection‐molding cycle and the effect of machine compliance on mold behavior. The mold cavity pressure obtained using MoldFlow™ was used as input for the subsequent finite element mold deflection analysis. Two different structural models were used: the first model included only the mold, the mold base units and the ejector platen; the second model included the effect of the injection‐molding machine compliance. To validate the model, strain gage rosettes were placed on the mold and the machine. Validating experiments were conducted using process parameters identical to those used in the simulations. A comparison of the experimental and simulation results for both models is presented. POLYM. ENG. SCI., 46:844–852, 2006. © 2006 Society of Plastics EngineersKeywords
This publication has 4 references indexed in Scilit:
- Predicting fill patterns for the in-mould coating process for thermoplastic partsModelling and Simulation in Materials Science and Engineering, 2004
- Investigation of mold plate separation in thin‐wall injection moldingAdvances in Polymer Technology, 2003
- Nature of contact between polymer and mold in injection molding. Part II: Influence of mold deflection on pressure history and shrinkagePolymer Engineering & Science, 2000
- The effect of the packing parameters, gate geometry, and mold elasticity on the final dimensions of a molded partPolymer Engineering & Science, 1996