Improving aramid pulp dispersion in epoxy resin via the in situ preparation of SiO2 on an aramid pulp surface
Authors:
- 26 December 2019
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 41 (4) , 1683-1693
Abstract
Aramid pulp (AP) is a highly fibrillated form of fiber, with excellent heat resistance, wear resistance, size stability, and other beneficial properties, that can be dispersed in rubber or resin matrix systems. Its fibrillation results in a large surface area. However, AP easily tangles and aggregates between fibers because of its large surface area. Consequently, it experiences difficulty in dispersing in matrices, especially when a relatively large amount of pulp is needed to be mixed. In this study, a SiO2 nanoparticle was synthesized on the surface of AP through the hydrolysis of tetraethyl orthosilicate to improve the dispersion of AP in an epoxy matrix. Fourier transform infrared spectroscopy, X‐ray diffraction, thermogravimetric analysis, X‐ray photoelectron spectroscopy, and scanning electron microscopy showed that SiO2 nanoparticles coated on the pulp could improve the thermal and mechanical properties. The optimum treatment concentration was 0.15 mol/L. Dynamic mechanical analysis tests indicated when AP modified by SiO2, the E' is higher due to the uniformly diffusion and enhanced interfacial adhesion for load transfer from the epoxy to AP. But Tg is lower as the flexibility chain SiOSi in epoxy. In comparison with the properties of the unmodified AP, the tensile strength and modulus of modified pulp/epoxy composites increased by 53.5% and 160.4%, respectively. Therefore, the dispersion and interface combination of AP modified by SiO2 in the epoxy improved because of the interaction of AP with SiO2 through the hydrogen bonding and crosslinking of SiO2 with epoxy.Keywords
Funding Information
- National Natural Science Foundation of China (51603120 11604204)
- Donghua University
- State Key Laboratory for Modification of Chemical Fibers and Polymer Materials
This publication has 26 references indexed in Scilit:
- Highly mechanical nanostructured aramid-composites with gradient structuresComposites Part A: Applied Science and Manufacturing, 2019
- Effect of fibre orientations on the mechanical properties of kenaf–aramid hybrid composites for spall-liner applicationDefence Technology, 2016
- Preparation of electroless silver plating on aramid fiber with good conductivity and adhesion strengthColloids and Surfaces A: Physicochemical and Engineering Aspects, 2015
- Enhanced interfacial properties of domestic aramid fiber-12 via high energy gamma ray irradiationComposites Part B: Engineering, 2015
- Surface modification of aramid fibres by graphene oxide nano-sheets for multiscale polymer compositesSurface and Coatings Technology, 2014
- Nitrile butadiene rubber-based heat-shielding insulations for solid rocket motorsHigh Performance Polymers, 2014
- The effect of oxygen-plasma treatment on Kevlar fibers and the properties of Kevlar fibers/bismaleimide compositesApplied Surface Science, 2011
- Properties of syndiotactic polystyrene composites with surface modified short Kevlar fiberMaterials Science and Engineering: A, 2006
- Polymerization compounding of HDPE/Kevlar composites. I. Morphology and mechanical propertiesPolymer Composites, 2006
- Effect of Chemical Treatment of Kevlar Fibers on Mechanical Interfacial Properties of CompositesJournal of Colloid and Interface Science, 2002