Current and Potential Fluctuation Characteristics in Intergranular Stress Corrosion Cracking Processes of Stainless Steels
Authors:
- 1 December 2000
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 56 (12) , 1250-1255
Abstract
Electrochemical noise behavior of Type 304 austenitic stainless steel (UNS S30400) with various degrees of sensitization was investigated under slow strain rate tensile (SSRT) conditions in a dilute sodium thiosulfate (Na2S2O3) solution. Fluctuations in short-circuit current between a SSRT specimen and a counter electrode under freely corroding potential and in corrosion potential were simultaneously monitored. Current and potential fluctuation behavior was dependent on the degree of sensitization. No significant fluctuation was detected from a slightly sensitized sample where no stress corrosion cracking (SCC) was found, and only constant anodic current was observed from a highly sensitized material after the yield point without any transition behavior. Transition electrochemical noise behavior was observed for current and potential for a moderately sensitized material. Most pulses were detected after the yield point, and the frequency of pulse generation gradually increased as strain was increased and finally changed into constant current mode. A one-to-one comparison was made between current pulses and surface damage for an interrupted SSRT specimen, and a direct correlation was found between each pulse and a crack initiation event. Current pulses had a one-to-one consistency to the time differential of the corresponding potential signals, dE/dt. This indicated that double-layer capacitance exerted a dominant role on the cathodic reaction during the initiation stage of SCC.Keywords
This publication has 13 references indexed in Scilit:
- Potential fluctuation during early stage of stress corrosion cracking of type-304 stainless steel in chloride solutionMaterials Science and Engineering: A, 1995
- Ultrasonic Quantitative Nondestructive Evaluation of AnisotropyJournal of the Society of Materials Science, Japan, 1994
- New Method for Analyzing Corrosion Potential Fluctuation in Stress Corrosion Cracking TestsJournal of the Society of Materials Science, Japan, 1993
- Electrochemical noise measurements of stress corrosion cracking of sensitised austenitic stainless steel in high-purity oxygenated water at 288°CCorrosion Science, 1992
- The mechanism of intergranular stress corrosion cracking of sensitised austenitic stainless steel in dilute thiosulphate solutionCorrosion Science, 1992
- Analysis of corrosion potential fluctuation for stress corrosion crackingCorrosion Science, 1990
- Electrochemical Noise Generation During Stress Corrosion Cracking of the High-Strength Aluminum AA 7075-T6 AlloyCorrosion, 1989
- Initiation of Stress Corrosion Cracking of Sensitized Type 304 Stainless Steel in Dilute Thiosulfate SolutionJournal of the Electrochemical Society, 1988
- Study on Stress Corrosion Cracking by Spectral AnalysisJournal of the Society of Materials Science, Japan, 1988
- Correlation of acoustic and electrochemical noise in the stress-corrosion cracking of α-brassScripta Metallurgica, 1983