Delay lines based on a suspended thin film of X-cut lithium niobate
Authors:
- 1 September 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
We report on the fabrication, experimental characterization, and theoretical modeling of delay lines fabricated on a lithium niobate X-cut thin film substrate. We demonstrate the feasibility of fabricating delay lines on lithium niobate suspended thin films to take advantage of the high electromechanical coupling of Lamb waves in this material. Specifically, we design the delay lines with an orientation of 30° with respect to the Y axis to maximize the coupling coefficient for the propagation of the S 0 mode. We show a maximum delay of 1.35 μs. Furthermore, the practically zero stress exhibited by the thin film point to the fact that larger delays could be easily achieved. The propagation loss measured is around 12 dB/cm, or equivalently, 7.5 dB/μs.Keywords
This publication has 5 references indexed in Scilit:
- Investigation of acoustic waves in thin plates of lithium niobate and lithium tantalateIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2001
- Materials and their influence on performance1978
- Surface-acoustic-wave resonatorsProceedings of the IEEE, 1976
- Applications of Double Electrodes in Acoustic Surface Wave Device Design1972
- Acoustic surface wave filtersProceedings of the IEEE, 1971