Single-Wall Carbon Nanotube Doping in Lead-Acid Batteries: A New Horizon
- 12 January 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 9 (4) , 3634-3643
Abstract
The addition of single-wall carbon nanotubes (SWCNT) to lead-acid battery electrodes is the most efficient suppresser of uncontrolled sulfation processes. Due to the cost of SWCNT, we studied the optimization loading of SWCNT in lead-acid battery electrodes. We optimized the SWCNT loading concentrations in both the positive and negative plates, separately. Loadings of 0.01% and 0.001% in the positive and negative active masses were studied, respectively. Two volts of lead-acid laboratory cells with sulfuric acid, containing silica gel-type electrolytes, were cycled in a 25% and 50% depth-of-discharge (DOD) cycling with a charging rate of C and 2C, respectively, and discharge rates of C/2 and C, respectively. All tests successfully demonstrated an excellent service life up to about 1700 and 1400 cycles for 25% and 50% DOD operations, respectively, at a low loading level of SWCNT. This performance was compared with CNT-free cells and cells with a multiwall carbon nanotube (MWCNT) additive. The outstanding performance of the lead-acid cells with the SWCNT additive is due to the oxidative stability of the positive plates during charging and the efficient reduction in sulfation in both plates while forming conducting active-material matrices.Keywords
This publication has 30 references indexed in Scilit:
- Characterization of lead (Ⅱ)-containing activated carbon and its excellent performance of extending lead-acid battery cycle life for high-rate partial-state-of-charge operationJournal of Power Sources, 2015
- Influence of some nanostructured materials additives on the performance of lead acid battery negative electrodesElectrochimica Acta, 2014
- Effect of graphene and carbon nanotubes on the negative active materials of lead acid batteries operating under high-rate partial-state-of-charge operationRSC Advances, 2014
- An in situ generated carbon as integrated conductive additive for hierarchical negative plate of lead-acid batteryJournal of Power Sources, 2014
- Multi-Walled Carbon Nanotubes Percolation Network Enhanced the Performance of Negative Electrode for Lead-Acid BatteryJournal of the Electrochemical Society, 2012
- Optimization studies of carbon additives to negative active material for the purpose of extending the life of VRLA batteries in high-rate partial-state-of-charge operationJournal of Power Sources, 2010
- The use of activated carbon and graphite for the development of lead-acid batteries for hybrid vehicle applicationsJournal of Power Sources, 2010
- Studies of doped negative valve-regulated lead-acid battery electrodesJournal of Power Sources, 2009
- Lithium-Ion Batteries2009
- Premature capacity loss (PCL) of the positive lead/acid battery plate: a new concept to describe the phenomenonJournal of Power Sources, 1993