Designing interlayers to improve the mechanical reliability of transparent conductive oxide coatings on flexible substrates
Open Access
- 1 May 2012
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 111 (9) , 093505
Abstract
In this study, we investigate the effect of interlayers on the mechanical properties of transparent conductive oxide (TCO) on flexible polymer substrates. Indium tin oxide (ITO), which is the most widely used TCO film, and Ti, which is the most widely used adhesive interlayer, are selected as the coating and the interlayer, respectively. These films are deposited on the polymer substrates using dc-magnetron sputtering to achieve varying thicknesses. The changes in the following critical factors for film cracking and delamination are analyzed: the internal stress (σi) induced in the coatings during deposition using a white light interferometer, the crystallinity using a transmission electron microscope, and the surface roughness of ITO caused by the interlayer using an atomic force microscope. The resistances to the cracking and delamination of ITO are evaluated using a fragmentation test. Our tests and analyses reveal the important role of the interlayers, which significantly reduce the compressive σi that is induced in the ITO and increase the resistance to the buckling delamination of the ITO. However, the relaxation of σi is not beneficial to cracking because there is less compensation for the external tension as σi further decreases. Based on these results, the microstructural control is revealed as a more influential factor than σi for improving crack resistance.Keywords
This publication has 31 references indexed in Scilit:
- Estimation of interfacial fracture toughness based on progressive edge delamination of a thin transparent coating on a polymer substrateActa Materialia, 2010
- The relationship between thin film fragmentation and buckle formation: Synchrotron-based in situ studies and two-dimensional stress analysisActa Materialia, 2009
- Evaluation of thin film adhesion to a compliant substrate by the analysis of progressive buckling in the fragmentation testThin Solid Films, 2009
- Cracking and decohesion of a thin Al2O3 film on a ductile Al–5%Mg substrateActa Materialia, 2005
- Mechanical analysis of ultrathin oxide coatings on polymer substrates in situ in a scanning electron microscopeThin Solid Films, 2003
- Effects of line and passivation geometry on curvature evolution during processing and thermal cycling in copper interconnect linesActa Materialia, 2000
- Fracture mechanics analysis of coating/substrate systemsEngineering Fracture Mechanics, 2000
- Electrical and Structural Properties of Tin-Doped Indium Oxide Films Deposited by DC Sputtering at Room TemperatureJapanese Journal of Applied Physics, 1999
- Large deformation and geometric instability of substrates with thin-film depositsJournal of Applied Physics, 1997
- Small and large deformation of thick and thin-film multi-layers: Effects of layer geometry, plasticity and compositional gradientsJournal of the Mechanics and Physics of Solids, 1996