In vitro comparison of high-resolution USG, CBCT, and direct measurements of periodontal defects
Open Access
- 26 March 2025
- journal article
- Published by Oxford University Press (OUP) in Dentomaxillofacial Radiology
- Vol. 54 (6) , 437-445
Abstract
Objectives: To compare the accuracy of cone-beam CT (CBCT), ultrasonography (USG) and direct measurements in linear dimensions of periodontal defects on the buccal alveolar surfaces of mandibular sheep teeth. Methods: A total of 88 defects were artificially created, including dehiscence, fenestration, grade I and II endodontic-periodontal defects. Two observers performed measurements twice. Maximum length, depth, and width of the defects were measured with all 3 methods. Manual measurements were accepted as the gold standard. Intraclass correlation coefficients (ICC) were calculated. The mean value of the measurements, the bias, the SD of the differences, and the limits of agreement were estimated. Statistical significance was set at P < .05. Results: Intra- and inter-observer reliability was excellent, suggesting ICCs 0.988-1 and 0.981-1, respectively. The highest CCs were obtained from depth measurements, while the lowest CCs were obtained from length measurements. Although the differences were scattered around the bias. The estimated bias values for USG and CBCT were 0.18 (0.153-0.21) (P < .001) and 0.091 (0.079-0.102) (P < .001), respectively. Observers recorded measurements which were slightly underestimated with both techniques utilized. Conclusions: Observers measured periodontal defects with clinically acceptable underestimations by using CBCT and USG. Advances in knowledge: It is important to compare different innovative imaging modalities and gauge their efficiency in the measurement of various types of periodontal defects in terms of treatment planning, prognosis, and follow up of those cases.Keywords
This publication has 48 references indexed in Scilit:
- Assessment of periodontal dehiscence and fenestration using ultrasonography and cone-beam computed tomography: an in vitro studyClinical Oral Investigations, 2024
- The repeatability of periodontal imaging with intraoral ultrasound scanningClinical Oral Investigations, 2024
- Ex vivo assessment of the buccal and oral bone by CBCTJournal of Orofacial Orthopedics / Fortschritte der Kieferorthopädie, 2021
- Effect of section thickness on cone beam computed tomography‐based measurements of intrabony defects compared with clinical measurementsJournal of Periodontology, 2020
- Ultrasonography for chairside evaluation of periodontal structures: A pilot studyJournal of Periodontology, 2019
- Ex vivo comparison of CBCT and digital periapical radiographs for the quantitative assessment of periodontal defectsClinical Oral Investigations, 2019
- Gingival thickness assessment at the mandibular incisors with four methods: A cross‐sectional studyJournal of Periodontology, 2018
- Periodontitis: Consensus report of workgroup 2 of the 2017 World Workshop on the Classification of Periodontal and Peri‐Implant Diseases and ConditionsJournal of Periodontology, 2018
- Why Bland–Altman plots should use X, not (Y+X)/2 when X is a reference methodStatistics in Medicine, 2007
- Repeatability of ultrasonic determination of gingival thicknessClinical Oral Investigations, 2007