Noncontact scanning force microscopy based on a modified tuning fork sensor
- 1 August 2000
- journal article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 71 (8) , 3104-3107
Abstract
Distance control using a tuning fork setup for the detection of shear forces is a standard configuration in scanning near-field optical microscopy (SNOM). Based on this concept, a modified sensor was developed, where a standard silicon tip for atomic force microscopy (AFM) is attached to the front end of one prong of a 100 kHz quartz tuning fork oscillator. Comparison of force curves of a standard tapping-mode AFM cantilever, a conventional fiber tip SNOM sensor and the novel AFM tip shear force sensor demonstrate an enhanced stability and sensitivity of the new sensor. Due to the rigid sensor design the force curves of the AFM tip shear force sensor indicate a perfect noncontact behavior under normal conditions in air. Noncontact images show a comparable resolution to conventional force microscopy.Keywords
This publication has 12 references indexed in Scilit:
- Fast low-cost phase detection setup for tapping-mode atomic force microscopyReview of Scientific Instruments, 1999
- Determination of elastic properties of single aerogel powder particles with the AFMUltramicroscopy, 1998
- Dynamic behavior of tuning fork shear-force feedbackApplied Physics Letters, 1997
- Cantilever dynamics in quasinoncontact force microscopy: Spectroscopic aspectsPhysical Review B, 1996
- Imaging soft samples with the atomic force microscope: gelatin in water and propanolBiophysical Journal, 1995
- Piezoelectric tip-sample distance control for near field optical microscopesApplied Physics Letters, 1995
- Functional Group Imaging by Chemical Force MicroscopyScience, 1994
- Combined shear force and near-field scanning optical microscopyApplied Physics Letters, 1992
- Scanning near-field acoustic microscopyApplied Physics B, 1989
- Atomic Force MicroscopePhysical Review Letters, 1986