Combination of citric acid and maltodextrin as bonding agent in sorghum bagasse particleboard
Authors:
- F A SyamaniFSF A Syamani
- D RamatiaDRD Ramatia
- SudarmantoSUSudarmanto
- F AkbarFAF Akbar
- S S KusumahSKS S Kusumah
- D HermawanDHD Hermawan
Open Access
- 1 September 2020
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 935 (1)
Abstract
The interest of using natural binder in particleboard production is still the primary concern of many researchers. The use of citric acid as an adhesive has been investigated and show satisfying results, especially in particleboard physical properties. However, the particleboard had low bending strength due to high content of citric acid on the particleboard affected the brittleness of the particles. Therefore, the application of citric acid in particleboard production usually combined with other natural adhesives. In this study, a combination of citric acid (CA) and maltodextrin (MD) was used in the production of sorghum bagasse particleboard with a ratio of 1:1. The particleboard was produced with a target density of 0.8 g/cm3, using 15%, 20%, 25% and 30% CA-MD content, hot-pressed at 200°C and 5 MPa for 8 or 10 minutes. The mixture of citric acid and maltodextrin (1:1) was successfully acting as bonding agent in sorghum bagasse particleboard production, mainly when used at 30% adhesive content. The particleboard modulus of rupture and modulus of elasticity, fulfilled the standard of type 8 particleboard, according to JIS 5908. The particleboard physical properties were excellent, proved by the value of particleboard thickness swelling, which was under 12%. This is due to the superb bonding from the combination of citric acid and maltodextrin, as shown by the internal bond values, which exceeded 0.3 N/mm2, the minimum requirement for type 18 particleboards based on JIS A 5908.Keywords
This publication has 13 references indexed in Scilit:
- Utilization of sweet sorghum bagasse and citric acid for manufacturing of particleboard I: Effects of pre-drying treatment and citric acid content on the board propertiesIndustrial Crops and Products, 2016
- Bio-based thermosets: Effect of the structure of polycarboxylic acids on the thermal crosslinking of maltodextrinsEuropean Polymer Journal, 2016
- Pretreatment of lignocellulose: Formation of inhibitory by-products and strategies for minimizing their effectsBioresource Technology, 2016
- Investigation of a new natural adhesive composed of citric acid and sucrose for particleboard II: effects of board density and pressing temperatureJournal of Wood Science, 2014
- Investigation of a new natural adhesive composed of citric acid and sucrose for particleboardJournal of Wood Science, 2013
- Reducing sugars production from sugarcane bagasse wastes by hydrolysis in sub-critical waterClean Technologies and Environmental Policy, 2012
- Effects of heat treatment on brittleness of Styrax tonkinensis woodJournal of Wood Science, 2007
- Polycarboxylic acids as non-formaldehyde anti-swelling agents for woodHolzforschung, 2006
- Refining sweet sorghum to ethanol and sugar: economic trade-offs in the context of North ChinaBioresource Technology, 2005
- Preparation, characterization, and performance of cross-linkable maltodextrin-based lignocellulosic adhesivesJournal of Adhesion Science and Technology, 2002