CFD Simulations Devoted to the Study of Fitting Effects on the Phase Distribution in Parallel Vertical Channels
- 1 December 2015
- journal article
- Published by Walter de Gruyter GmbH in International Journal of Chemical Reactor Engineering
- Vol. 13 (4) , 551-559
Abstract
Uneven distribution of phases in plate heat exchangers is a cause of reduction in both thermal and fluid-dynamic performances. With respect to two-phase flows, phase separation in manifolds with several outlets is a complex phenomenon and no general rules are available for predicting the phase distribution at header–channel junctions. The design of compact heat exchangers and their distributors is still based on empirical approaches and both experimentation and numerical analyses are needed for defining the best geometries able to reduce the mass flow rate non-uniformities in parallel channels. In this paper, a series of CFD simulations are carried out to infer the effects of a protrusion fitting (inside the header) on the single-phase distribution in parallel upward vertical channels fed by a common horizontal distributor. The numerical results are compared with both experimental single-phase and two-phase (liquid/gas) experimental data. The effects of the operating conditions are investigated and general conclusions on the differences and analogies between single-phase and two-phase flows in the present problem are discussed.Keywords
This publication has 10 references indexed in Scilit:
- Review on two-phase flow distribution in parallel channels with macro and micro hydraulic diameters: Main results, analyses, trendsApplied Thermal Engineering, 2013
- Improvement of two-phase refrigerant distribution in a parallel flow minichannel heat exchanger using insertion devicesApplied Thermal Engineering, 2013
- Distribution of air–water mixtures in parallel vertical channels as an effect of the header geometryExperimental Thermal and Fluid Science, 2009
- Distribution of two-phase annular flow at header–channel junctionsExperimental Thermal and Fluid Science, 2004
- Modelling the Split of Horizontal Annular Flow at a T-JunctionChemical Engineering Research and Design, 1999
- Phase separation in dividing two-phase flowsInternational Journal of Multiphase Flow, 1988
- Review of various Types of Flow Maldistribution in Heat ExchangersHeat Transfer Engineering, 1988
- Flow distribution and pressure drop in plate heat exchangers—I U-type arrangementChemical Engineering Science, 1984
- Flow Distribution ManifoldsJournal of Fluids Engineering, 1976
- Flow distributions in manifoldsChemical Engineering Science, 1959