Thermal Performance of a Massive Wall in the Mediterranean Climate: Experimental and Analytical Research
Open Access
- 3 July 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (13) , 4611
Abstract
In the Mediterranean climate, indoor overheating and, thus, excessive use of cooling systems represents one of the main problems both for the occupants’ health and energy consumption. In order to limit this problem, an appropriate design or energy retrofitting of the building envelope is of utmost importance. The predominance of massive buildings in the Italian territory and the need to comply with Italian regulations often leads technicians to not optimal energy saving solutions. To this purpose, this experimental research was conducted on a mockup building, located in Fabriano and characterized by high thermal mass walls (W0) and two different external insulating systems: Cork based lightweight plaster (W1) and Extruded polystyrene foam panel (XPS) (W2). Furthermore, a virtual model in TRNSYS, a transient simulation software, was used to compare analytical and simulated values. Results show that W2 undergoes a higher level of thermal stress than W1, due to higher peaks in the external surface temperature and larger fluctuations in daily temperature. Therefore, a high value of thermal resistance of the external insulation and low value of external areal heat capacity on a massive building causes external surface overheating problems, thus, not representing the optimal construction solution.Keywords
This publication has 24 references indexed in Scilit:
- Multi-objective optimization analysis for high efficiency external walls of zero energy buildings (ZEB) in the Mediterranean climateEnergy and Buildings, 2014
- External walls design: The role of periodic thermal transmittance and internal areal heat capacityEnergy and Buildings, 2014
- The influence of concrete density and conductivity on walls’ thermal inertia parameters under a variety of masonry and insulation placementsApplied Energy, 2013
- Experimental comparison between 3 different traditional wall constructions and dynamic simulations to identify optimal thermal insulation strategiesEnergy and Buildings, 2013
- Passive cooling dissipation techniques for buildings and other structures: The state of the artEnergy and Buildings, 2013
- Energy and microclimatic performance of Mediterranean vernacular buildings: The Sassi district of Matera and the Trulli district of AlberobelloBuilding and Environment, 2013
- Influence of the internal inertia of the building envelope on summertime comfort in buildings with high internal heat loadsEnergy and Buildings, 2011
- The influence of the external walls thermal inertia on the energy performance of well insulated buildingsEnergy and Buildings, 2009
- Modeling daylight availability and irradiance components from direct and global irradianceSolar Energy, 1990
- Diffuse fraction correlationsSolar Energy, 1990