Migration from acrylonitrile butadiene styrene (ABS) polymer: swelling effect of food simulants compared to real foods
Open Access
- 2 January 2021
- journal article
- research article
- Published by Springer Nature in Journal of Consumer Protection and Food Safety
- Vol. 16 (1) , 19-33
Abstract
Materials and articles made of acrylonitrile–butadiene–styrene (ABS) intended for contact with food must comply with the requirements of the European Plastic Regulation (EU) 10/2011, which lays down the food simulants and the time/temperature conditions to be applied for migration testing. Previous studies indicated that high concentrations of ethanol at temperatures above ambient may lead to swelling of ABS polymers resulting in increased migration. In this study migration kinetic data for a set of model substances at different temperatures were obtained using both food simulants stipulated in EU regulations and real food (milk, cream and olive oil). At the same time, the extent of polymer swelling was gravimetrically characterized after contact with simulants and different foods tested at several conditions to cover the majority of foreseeable applications of ABS. The obtained results confirmed that the use of high concentrations of ethanol–water, especially at high temperatures, causes the swelling of ABS polymers and results in significantly higher migration values compared to the tested foods as well as Tenax®. None of the real foods studied cause significant swelling of ABS. The widely used simulant 95% (v/v) aqueous ethanol proves not be suitable for compliance testing of ABS under the recommended conditions of Regulation (EU) 10/2011. Swelling of the polymer results in artificially higher diffusion coefficients or lower activation energies of diffusion. Migration prediction using polymer-specific diffusion parameters should therefore be considered to avoid over-conservative risk assessment for food contact materials and articles made of ABS.Keywords
Funding Information
- Fraunhofer Institute for Process Engineering and Packaging (IVV)
This publication has 10 references indexed in Scilit:
- Migration Testing of Polyethylene Terephthalate: Comparison of Regulated Test Conditions with Migration into Real Food at the End of Shelf LifePackaging Technology and Science, 2017
- Updated evaluation of the migration of styrene monomer and oligomers from polystyrene food contact materials to foods and food simulantsFood Additives & Contaminants: Part A, 2014
- Migration of styrene monomer, dimers and trimers from polystyrene to food simulantsFood Additives & Contaminants, 2005
- Migration of mineral hydrocarbons into foods. 2. Polystyrene, ABS, and waxed paperboard containers for dairy productsFood Additives & Contaminants, 1993
- The migration of acrylonitrile from acrylonitrile/butadiene/styrene polymers into food-simulating liquidsFood and Chemical Toxicology, 1991
- Single ion monitoring of butadiene in plastics and foods by coupled mass spectrometry—automatic headspace gas chromatographyJournal of Chromatography A, 1984
- Determination of acrylonitrile monomer in food packaging materials and in foodsFood Chemistry, 1982
- Identification of CNP, Chlomethoxynil and TCNP in CorbiculaFood Hygiene and Safety Science (Shokuhin Eiseigaku Zasshi), 1981
- Fracture initiation and crack propagation of acrylonitrile-butadiene-styrene (ABS) in organic solventsJournal of Materials Science, 1976
- The Mathematics of Diffusion. By J. Crank. Pp. vii, 347. 50s. 1956. (Clarendon Press)The Mathematical Gazette, 1958