Design and Implementation of Constant Speed control System for the Induction motors Using Programmable logic Controller (PLC) and Variable Frequency Derive (VFD)
Open Access
- 1 February 2021
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 1076 (1) , 012007
Abstract
This paper presents an automatic speed control system on three phase squirrel cage induction motor using Programming Logic Circuit (PLC) and Variable Frequency Drive (VFD) techniques. The aim of this study is to obtain a constant speed of induction motors when these motors are exposed to variable loads. The required speed of the induction motor can be set as a numerical value by (PLC), while the actual speed of the induction motor can be measured by a tachometer which is equipped with (PLC) ) Through an Analog to Digital Converter (ADC). Then the two speeds are compared to the set point with minimum error to get the required constant speed. The control system designed to be tested with two stator poles number (two and four poles) of induction motors. The results have cleared that in spite of doubled the load 11 and 8 times respectively, but the yield average shaft speeds are almost constant 2891.15 rpm and 1402.45 rpm respectively.Keywords
This publication has 2 references indexed in Scilit:
- 3 Phase Induction Motor Control Using Single Phase Input and GSMInternational Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, 2015
- Monitoring and control of a PLC based VFD fed three phase induction motor for powder compacting press machine2013