Application of the Teager-Kaiser energy operator in diagnostics of a hydrodynamic bearing
Authors:
- Jędrzej BlautJBJędrzej Blaut
- Łukasz BreńkaczŁBŁukasz Breńkacz
- 31 December 2020
- journal article
- research article
- Published by Polskie Naukowo-Techniczne Towarzystwo Eksploatacyjne in Eksploatacja i Niezawodność – Maintenance and Reliability
- Vol. 22 (4) , 757-765
Abstract
The paper presents the use of the Teager-Kaiser energy operator (TKEO) to evaluate the state of rotor unbalance. The method was developed in 1990 by Kaiser and involves a simple calculation of signal energy. It has been used before in diagnostics, e.g. during the evaluation of instability of hydrodynamic bearings and as a diagnostic symptom of gearbox damage. This paper is the first to present the use of the Teager-Kaiser method to evaluate the rotor unbalance in hydrodynamic bearings.Keywords
This publication has 23 references indexed in Scilit:
- Analytical modelling and numerical experiment for simultaneous identification of unbalance and rolling-bearing coefficients of the continuous single-disc and single-span rotor-bearing system with Rayleigh beam modelMechanical Systems and Signal Processing, 2019
- Unbalance and resonance elimination with active bearings on general rotorsJournal of Sound and Vibration, 2018
- Dynamic response of a cracked rotor with an unbalance influenced breathing mechanismJournal of Mechanical Science and Technology, 2018
- Application of energy operators for detection of failures in gearboxesMechanics Research Communications, 2017
- Unbalance and resonance elimination with active bearings on a Jeffcott RotorMechanical Systems and Signal Processing, 2017
- Discussion on adaptation of linear decimation procedures for TFR analysis of non-stationary vibration signals of vehicle suspensionMechanics Research Communications, 2016
- Rotor Unbalance Estimation with Reduced Number of SensorsMachines, 2016
- The Influence of Rotor Unbalance on Turbocharger Rotor DynamicsJournal of Middle European Construction and Design of Cars, 2015
- A time–frequency analysis approach for condition monitoring of a wind turbine gearbox under varying load conditionsMechanical Systems and Signal Processing, 2015
- On a simple algorithm to calculate the 'energy' of a signal2002