Improvement of the tribological behavior of ultra‐high‐molecular‐weight polyethylene by incorporation of poly (phenyl p‐hydroxyzoate)
Authors:
- 14 April 2005
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 96 (6) , 2336-2343
Abstract
Ultra‐high‐molecular‐weight polyethylene/poly (phenyl p‐hydroxyzoate) composites (coded as UHMWPE/PPHZ) were prepared by compression molding. The effects of the poly (phenyl p‐hydroxyzoate) on the tribological properties of the UHMWPE/PPHZ composites were investigated, based on the evaluations of the tribological properties of the composites with various compositions and the examinations of the worn steel surfaces and composites structures by means of scanning electron microscopy and transmission electron microscopy. It was found that the incorporation of the PPHZ led to a significant decrease in the wear rate of the composites. The composites with the volume fraction of the PPHZ particulates within 45% ∼ 75% showed the best wear resistance. The friction coefficient of the UHMWPE/PPHZ composites decreased with increasing load and sliding velocity, while the wear rates increased with increasing load. This was attributed to the enhanced softening and plastic deformation of the composites at elevated load or sliding velocity. The UHMWPE/PPHZ composites of different compositions had differences in the microstructures and the transfer film characteristics on the counterpart steel surface as well. This accounted for their different friction and wear behaviors. The transfer film of the UHMWPE/PPHZ composites appeared to be thinner and more coherent, which was largely responsible for their better wear resistance of t composite than the UHMWPE matrix. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 96: 2336–2343, 2005Keywords
This publication has 16 references indexed in Scilit:
- Effects of operating parameters on the lubricated wear behavior of a PA-6/UHMWPE blend: a statistical analysisWear, 2002
- Creep and wear behaviour of ethylene–butene copolymers reinforced by ultra-high molecular weight polyethylene fibresWear, 2002
- Tribological action of metallic fillers in poly(tetrafluoroethylene) compositesJournal of Applied Polymer Science, 2002
- The friction and wear characteristics of nanometer ZnO filled polytetrafluoroethyleneWear, 2001
- Friction and wear properties of UHMWPE/Al2O3 ceramic under different lubricating conditionsWear, 2001
- Study of a compatibilized ultra‐high‐molecular‐weight polyethylene and polyurethane blendJournal of Applied Polymer Science, 2001
- Wear behavior of bulk oriented and fiber reinforced UHMWPEWear, 2000
- Advances in the processing, sterilization, and crosslinking of ultra-high molecular weight polyethylene for total joint arthroplastyBiomaterials, 1999
- Wear and friction properties of prosthetic joint materials evaluated on a reciprocating pin-on-flat apparatusWear, 1993
- The nature of the thermal transitions in poly(p-oxybenzoate)Macromolecules, 1988