Thermal characteristics of unidirectional carbon fiber reinforced polymer laminates during orthogonal cutting
- 8 April 2018
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 37 (13) , 905-916
Abstract
Carbon fiber reinforced polymer has been used as a major material for primary load-bearing structural components in aviation industry. But its poor heat resistance is an important factor affecting the machining performance, because high cutting temperature above glass transition temperature of resin matrix (normally 300°C or below) may lead to the degradation of the resin matrix. In this study, orthogonal machining experiments were conducted to investigate the effects of cutting parameters, cutting tool geometric parameters, and material parameters on cutting temperature, and the prediction model of cutting temperature about fiber orientation angle (θ) was built. Cutting temperature was measured by semiartificial thermocouple method. The experimental results revealed that the influence of cutting parameters on cutting temperature was not affected by fiber orientation angle of carbon fiber reinforced polymer. Cutting tool geometric parameters have little effect on cutting temperature. Unlike metal materials, cutting temperature was greatly influenced by θ. Cutting temperature for θ < 90° was significantly higher than that for θ > 90°. The maximum temperature occurred at θ = 90°. The influence of fiber orientation angle was shown in two aspects: changing the springback of unidirectional-carbon fiber reinforced polymer laminates in cutting process, changing material removal mechanism, which affected cutting temperature eventually.Keywords
Funding Information
- National Natural Science Foundation of China (51405294)
- National Natural Science Foundation of China (51475298)
- National Natural Science Foundation of China (51705319)
- National Engineering and Research Center for Commercial Aircraft Manufacturing (COMAC-SFGS-2016-33277)
- Important National Science & Technology Specific Projects (2016ZX040070011)
This publication has 20 references indexed in Scilit:
- Carbon fiber-reinforced polymer composite drilling via aluminum chromium nitride-coated tools: Hole quality and tool wear assessmentJournal of Reinforced Plastics and Composites, 2017
- Mode II fracture toughness of CFRP as a function of temperature and strain rateComposites Part B: Engineering, 2017
- The influence of stitching and unconventional fibres orientation on the tensile properties of CFRP laminatesComposites Part B: Engineering, 2017
- Occurrence and formation mechanism of surface cavity defects during orthogonal milling of CFRP laminatesComposites Part B: Engineering, 2017
- Research on the carbon fibre-reinforced plastic (CFRP) cutting mechanism using macroscopic and microscopic numerical simulationsJournal of Reinforced Plastics and Composites, 2016
- An experimental study on drilling of unidirectional GLARE fibre metal laminatesComposite Structures, 2015
- Study on the cutting mechanics characteristics of high-strength UD-CFRP laminates based on orthogonal cutting methodComposite Structures, 2015
- Experimental analysis of special tool geometries when drilling woven and multidirectional CFRPsJournal of Reinforced Plastics and Composites, 2015
- Effects of tool parameters on cutting force in orthogonal machining of T700/LT03A unidirectional carbon fiber reinforced polymer laminatesJournal of Reinforced Plastics and Composites, 2015
- Mechanistic force modeling for milling of unidirectional carbon fiber reinforced polymer laminatesInternational Journal of Machine Tools and Manufacture, 2012