Research of Tribological Properties of 34CrNiMo6 Steel in the Production of a Newly Designed Self-Equalizing Thrust Bearing
Open Access
Abstract
There are many cases when in large power equipment (such as a turbine or compressor) asymmetrically loading on bearings due to thermal deformations, production inaccuracies, or simple deflection of the shaft occurs. This asymmetrically loading means misalignment of rotor against stator in angle more than several tenths of a degree and it has an influence on a journal and thrust bearings. Over the last few years, thanks to increasingly precise manufacturing, solutions that can eliminate this phenomenon have been revealed. In the case of the thrust bearing, it is a system of very precise manufactured levers, which are in close contact each to other, so they have to be not only properly designed from the geometrical point of view but the important role plays a quality of the functional surfaces of these levers. The article deals with the surface treatment effect on tribological properties of 34CrNiMo6 steel used for the production of bearing levers, which are the critical parts of a newly developing self-equalizing thrust bearing. The samples with cylindrical and plate shapes were produced from 34CrNiMo6 steel as representatives of the most suitable geometries for contact surfaces. All samples were heat-treated. The surfaces of some samples were treated by electroless nickel plating or nitriding, some of the samples were treated by tumbling. Gradually, the surface roughness, microhardness, metallographic analysis and the influence of selected types of surface treatments on the wear for individual samples were evaluated within the research presented in the article. As the testing methods for evaluation of tribological properties were selected Pin-on-disc test and frequency tribological test. The results showed that the best tribological properties achieved samples treated by electroless nickel plating compared with the nitrided or only heat-treated samples.Keywords
Funding Information
- Ministerstvo školstva, vedy, výskumu a športu Slovenskej republiky (APVV-19-0550 and KEGA 007TUKE-4/2018)
This publication has 31 references indexed in Scilit:
- A Short Review on Fracture Mechanisms of Mechanical Components Operated under Industrial Process Conditions: Fractographic Analysis and Selected Prevention StrategiesMetals, 2019
- Dependence of the Resistance of the Integrated Layers on the Wear of Ceramic Cutting ToolManufacturing Technology, 2018
- Influence mechanism of morphological parameters on tribological behaviors based on bearing ratio curveTribology International, 2017
- Analysis of the Degradation Process of Structural Steel Component Subjected to Prolonged Thermal ExposureMetallography, Microstructure, and Analysis, 2016
- Survey of Damage Investigation of Babbitted Industrial BearingsLubricants, 2015
- Designing Thrust Sliding Bearings of High Bearing CapacityProcedia Engineering, 2012
- Wear prevention behaviour of nanoparticle suspension under extreme pressure conditionsWear, 2007
- Test Results for PTFE-Faced Thrust Pads, With Direct Comparison Against Babbitt-Faced Pads and Correlation With AnalysisJournal of Tribology, 2003
- The Leading-Edge-Groove Tilting-Pad Thrust Bearing: Recent DevelopmentsJournal of Tribology, 1985
- Factors Influencing Power Loss of Tilting-Pad Thrust BearingsJournal of Lubrication Technology, 1979