Zero No-Load Power AC/DC Adapter for Electronic Equipment With Embedded Battery
Authors:
Open Access
- 1 July 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 28 (7) , 3073-3076
Abstract
A zero no-load power (ZNP) ac/dc adapter for electronic equipment with an embedded battery is proposed in this letter. The embedded battery is used as a signal source for the detection of load connection. Depending on the signal of load connection, an operation of the proposed ZNP ac/dc adapter is determined. When the proposed adapter is connected with a load system, the operation of the proposed adapter is the same as that of the conventional ac/dc adapter. While the proposed adapter is disconnected from the load system, the overall proposed adapter is totally turned off. Therefore, the proposed adapter can achieve ZNP consumption. To verify the validity of the proposed adapter, loss analysis and experimental results of 65 W are presented.Keywords
This publication has 7 references indexed in Scilit:
- Single switching double powering converter for reducing power consumption of AC/DC adapter in standby mode2011
- A new control method using JFET for an off-line flyback converter with low stand-by power consumption2011
- Sawtooth burst mode control with minimum peak current in stand-by operation of power supply2011
- Novel circuit design for two-stage AC/DC converter to meet standby power regulationsIET Power Electronics, 2009
- Switching Control Technique of Phase-Shift-Controlled Full-Bridge Converter to Improve Efficiency Under Light-Load and Standby Conditions Without Additional Auxiliary ComponentsIEEE Transactions on Power Electronics, 2009
- A High-Efficiency AC-to-DC Adaptor With a Low Standby Power ConsumptionIEEE Transactions on Industrial Electronics, 2008
- Standby power challenge2004