Formulation and curing characteristics of EPDM/NR and EPDM/SBR polyblends used in metallic surfaces rubber lining
- 30 March 2009
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 113 (2) , 849-854
Abstract
In this work, a new elastomeric liner was introduced to protect the metal surfaces of storage tanks against corroding materials in petrochemical industries. This new liner was prepared on the basis of EPDM/NR and EPDM/SBR compounds. The elastomeric compounds were cured by using super‐heated water vapor at atmospheric pressure. To increase the rate of curing in these rubber samples, the optimum curing system contained 15 phr sulfur and 1.5 phr mercaptobenzothiazole, 1.5 phr zinc diethyl dithiocarbamate, and 1.8 phr tetramethylthiuram disulfide accelerators. Mechanical tests showed that ultimate tensile strength, elongation at break, and hardness of both polyblend samples were comparable to the SBR/NR blend, which is widely used in the rubber lining of metallic surfaces. In the next step, the chemical resistance of the samples was measured by placing them in a 30 wt % HCl solution. The tensile strength, elongation at break, and weight loss of the samples were measured before and after immersion in HCl. Also, the chemical resistances for EPDM/NR, EPDM/SBR, and SBR/NR samples were qualitatively measured in caustic solution. The cracking, blistering, permeability, and adhesion of the rubber samples to steel surface were observed. Finally, the results showed that EPDM/SBR (70/30) polyblend can be a suitable substitute for conventionally used SBR/NR (50/50) for a successful rubber used to line metallic surfaces. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2009Keywords
This publication has 15 references indexed in Scilit:
- Influence of prolonging vulcanization on the structure and properties of hard rubberJournal of Applied Polymer Science, 2007
- The grafting of maleic anhydride onto natural rubberPolymer Testing, 2004
- Effects of Accelerator Type and Curing Temperature on Crosslink Distributions and Tensile Properties of Natural-Acrylic Rubber BlendsRubber Chemistry and Technology, 2003
- Preparation and characterization of maleic anhydride-functionalized syndiotactic polystyrenePolymer, 2002
- Bonding properties of rubber to steel, aluminium and nylon 6,6International Journal of Adhesion and Adhesives, 2001
- The synthesis of polyolefin graft copolymers by reactive extrusionProgress in Polymer Science, 1999
- Preparation of functionalized polystyrene by reactive extrusion and its blend with polyamide 6Polymer, 1996
- Structure of coatings and rubber linings exposed to operating stress in flue gas scrubbing systemsMaterials and Corrosion, 1992
- Kinetics of the zinc fluoborate- and hydrogen ion-catalyzed hydrolyses of butadiene diepoxidesJournal of Applied Polymer Science, 1965
- Studies in hard rubber reaction. Part I. Heat of hard rubber reactionJournal of Applied Polymer Science, 1962