Environmentally protected hot-stage atomic force microscope for studying thermo-mechanical deformation in microelectronic devices
Authors:
- 1 November 2004
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 75 (11) , 4662-4670
Abstract
A commercial atomic force microscope (AFM) was equipped with a hot stage for conducting thermal cycling experiments up to , as well as a vacuum and purge system to provide a protective environment during heating. Two different hot-stage configurations, one for studying features in the plane of a microelectronic device, and the other for studying features on its cross section, were developed. It is shown that the AFM retains its calibration with no significant introduction of errors at temperatures up to . Two applications of in situ hot-stage atomic force microscopy, related to microelectronic devices, have been demonstrated. First, the in-plane coefficient of thermal expansion of a low dielectric constant (low- ) thin film dielectric material used in back-end interconnect structures was measured. Second, the equipment was used to conduct in situ studies of deformation of Cu thin film interconnect lines at the back end of silicon chips, under thermo-mechanical loads simulating those imposed on chip-level interconnect structures by a microelectronic package. The design of a bimetallic thermo-mechanical loading stage, which was used for the latter experiments in conjunction with the hot stage, is also discussed.
Keywords
This publication has 18 references indexed in Scilit:
- An in-situ hot stage for temperature-dependent tapping-mode™ atomic force microscopyReview of Scientific Instruments, 1998
- A hydrothermal atomic force microscope for imaging in aqueous solution up to 150 °CReview of Scientific Instruments, 1998
- Scanning force microscope and vacuum chamber for the study of ice films: Design and first resultsReview of Scientific Instruments, 1998
- A scanning force microscope with atomic resolution in ultrahigh vacuum and at low temperaturesReview of Scientific Instruments, 1998
- Fiber interferometer-based variable temperature scanning force microscopeReview of Scientific Instruments, 1997
- Design and construction of a heat stage for investigations of samples by atomic force microscopy above ambient temperaturesReview of Scientific Instruments, 1997
- Temperature controlled microstage for an atomic force microscopeReview of Scientific Instruments, 1996
- Scanning Probe MicroscopyAnalytical Chemistry, 1996
- From Molecules to Cells: Imaging Soft Samples with the Atomic Force MicroscopeScience, 1992
- Atomic Force MicroscopePhysical Review Letters, 1986