Effect of citric acid concentration on dentin demineralization, dehydration, and rehydration: Atomic force microscopy study
Authors:
- 15 December 1998
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 42 (4) , 500-507
Abstract
Most current dentin bonding procedures use acid etchants to partially demineralize the dentin structure and provide pathways for resin infiltration. This study determined the recession rates of peritubular dentin and intertubular dentin as a function of pH during demineralization in citric acid solutions (0.0005–2.5M) and the effects of dehydration and rehydration on the partially demineralized dentin. Polished dentin disks were prepared with an internal reference layer and were studied at specific intervals for citric acid etching between pH 1 and 3.4 in an atomic force microscope. Peritubular dentin etched rapidly and linearly with time until it could no longer be measured. The intertubular surface began etching at nearly the same rate, but then recession slowed for all concentrations and stabilized after recession of less than 1 μm for all but the pH 1 solution. The decrease in recession was attributed to the limitation of contraction of the demineralized collagen scaffold as long as it remained hydrated. Dehydration following etching resulted in significant collapse of the surface, changes in roughness, and a slight decrease in tubule diameter for samples etched for 30 min. Measurements could not be made of the collapse for low pH samples, because shrinkage stresses disrupted the integrity of the reference layer. On rehydration, the dehydrated surfaces underwent an expansion up to the level seen after etching and tubule diameters returned to the etched values. These results indicate that the collapse of demineralized matrix is almost totally recoverable on rehydration. © 1998 John Wiley & Sons, Inc. J Biomed Mater Res, 42, 500–507, 1998.Keywords
This publication has 18 references indexed in Scilit:
- Viscoelastic properties of demineralized human dentin measured in water with atomic force microscope (AFM)-based indentationJournal of Biomedical Materials Research, 1998
- In vitro study on the dimensional changes of human dentine after demineralizationArchives of Oral Biology, 1996
- Atomic force microscopy of conditioning agents on dentinJournal of Biomedical Materials Research, 1995
- Mineral Distribution and Dimensional Changes in Human Dentin during DemineralizationJournal of Dental Research, 1995
- Atomic force microscopy studies of the interaction of a dentin adhesive with tooth hard tissueJournal of Biomedical Materials Research, 1994
- Atomic-force microscopic study of dimensional changes in human dentine during dryingArchives of Oral Biology, 1993
- Comparative SEM and TEM Examination of the Ultrastructure of the Resin-Dentin Interdiffusion ZoneJournal of Dental Research, 1993
- Improving Bond Strength Through Acid Etching of Dentin and Bonding to Wet Dentin SurfacesThe Journal of the American Dental Association, 1992
- Morphological Aspects of the Resin-Dentin Interdiffusion Zone with Different Dentin Adhesive SystemsJournal of Dental Research, 1992
- Scanning electron microscopic investigation of human dentinal tubulesArchives of Oral Biology, 1976