Reduced Order Modeling for First Order Hyperbolic Systems with Application to Multiparameter Acoustic Waveform Inversion
- 9 April 2025
- journal article
- Published by Society for Industrial & Applied Mathematics (SIAM) in SIAM Journal on Imaging Sciences
- Vol. 18 (2) , 851-880
Abstract
Waveform inversion seeks to estimate an inaccessible heterogeneous medium from data gathered by sensors that emit probing signals and measure the generated waves. It is an inverse problem for a second order wave equation or a first order hyperbolic system, with the sensor excitation modeled as a forcing term and the heterogeneous medium described by unknown, spatially variable coefficients. The traditional “full waveform inversion” (FWI) formulation estimates the unknown coefficients via minimization of the nonlinear, least squares data fitting objective function. For typical band-limited and high frequency data, this objective function has spurious local minima near and far from the true coefficients. Thus, FWI implemented with gradient based optimization algorithms may fail, even for good initial guesses. Recently, it was shown that it is possible to obtain a better behaved objective function for wave speed estimation, using data driven reduced order models (ROMs) that capture the propagation of pressure waves, governed by the classic second order wave equation. Here we introduce ROMs for vectorial waves, satisfying a general first order hyperbolic system. They are defined via Galerkin projection on the space spanned by the wave snapshots, evaluated on a uniform time grid with appropriately chosen time step. Our ROMs are data driven: They are computed in an efficient and noniterative manner, from the sensor measurements, without knowledge of the medium and the snapshots. The ROM computation applies to any linear waves in lossless and nondispersive media. For the inverse problem we focus attention on acoustic waves in a medium with unknown variable wave speed and density. We show that these can be determined via minimization of an objective function that uses a ROM based approximation of the vectorial wave field inside the inaccessible medium. We assess the performance of our inversion approach with numerical simulations and compare the results to those given by FWI.Keywords
All Related Versions
Funding Information
- Agence de l'innovation de Défense (PRODIPO)
- Air Force Office of Scientific Research (FA9550-22-1-0077)
- Office of Naval Research (N00014-21-1-2370)
- National Science Foundation (2309197)
This publication has 37 references indexed in Scilit:
- Design and Construction of a Low-Frequency Ultrasound Acquisition Device for 2-D Brain Imaging Using Full-Waveform InversionUltrasound in Medicine & Biology, 2022
- Reduced basis methods for time-dependent problemsActa Numerica, 2022
- A Reduced Order Model Approach to Inverse Scattering in Lossy Layered MediaJournal of Scientific Computing, 2021
- Optimal Transport Based Seismic Inversion:Beyond Cycle SkippingCommunications on Pure and Applied Mathematics, 2021
- A priori estimates of attraction basins for nonlinear least squares, with application to Helmholtz seismic inverse problemInverse Problems, 2019
- Data-Driven Science and Engineering2019
- Untangling the nonlinearity in inverse scattering with data-driven reduced order modelsInverse Problems, 2018
- A model reduction approach to numerical inversion for a parabolic partial differential equationInverse Problems, 2014
- Simultaneous nonlinear reconstruction of two‐dimensional permittivity and conductivityRadio Science, 1994
- Block-Arnoldi and Davidson methods for unsymmetric large eigenvalue problemsNumerische Mathematik, 1993