Br Vacancy Defects Healed Perovskite Indoor Photovoltaic Modules with Certified Power Conversion Efficiency Exceeding 36%
Authors:
Open Access
- 17 October 2022
- journal article
- research article
- Published by Wiley in Advanced Science
- Vol. 9 (33) , e2204138
Abstract
Indoor photovoltaics (IPVs) are expected to power the Internet of Things ecosystem, which is attracting ever‐increasing attention as part of the rapidly developing distributed communications and electronics technology. The power conversion efficiency of IPVs strongly depends on the match between typical indoor light spectra and the band gap of the light absorbing layer. Therefore, band‐gap tunable materials, such as metal‐halide perovskites, are specifically promising candidates for approaching the indoor illumination efficiency limit of ∼56%. However, perovskite materials with ideal band gap for indoor application generally contain high bromine (Br) contents, causing inferior open‐circuit voltage (VOC). By fabricating a series of wide‐bandgap perovskites (Cs0.17FA0.83PbI3−xBrx, 0.6 ≤ x ≤ 1.6) with varying Br contents and related band gaps, it is found that, the high Br vacancy (VBr) defect density is a significant reason that leading to large VOC deficits apart from the well‐accepted halide segregation. The introduction of I‐rich alkali metal small‐molecule compounds is demonstrated to suppress the VBr and increase the VOC of perovskite IPVs up to 1.05 V under 1000 lux light‐emitting diode illumination, one of the highest VOC values reported so far. More importantly, the modules are sent for independent certification and have gained a record efficiency of 36.36%.Keywords
Funding Information
- National Natural Science Foundation of China (62005099, 62104082, 62105124)
- Fundamental Research Funds for the Central Universities (21621024)
This publication has 51 references indexed in Scilit:
- Organic photovoltaics for low light applicationsSolar Energy Materials and Solar Cells, 2011
- Explicit model of photovoltaic panels to determine voltages and currents at the maximum power pointSolar Energy, 2011
- Thin‐film solar cells: device measurements and analysisProgress in Photovoltaics: Research and Applications, 2004
- From ultrasoft pseudopotentials to the projector augmented-wave methodPhysical Review B, 1999
- Efficient iterative schemes for ab initio total-energy calculations using a plane-wave basis setPhysical Review B, 1996
- Projector augmented-wave methodPhysical Review B, 1994
- Ab initiomolecular-dynamics simulation of the liquid-metal–amorphous-semiconductor transition in germaniumPhysical Review B, 1994
- Solar cell fill factors: General graph and empirical expressionsSolid-State Electronics, 1981
- Special points for Brillouin-zone integrationsPhysical Review B, 1976
- Detailed Balance Limit of Efficiency ofp-nJunction Solar CellsJournal of Applied Physics, 1961