Nylon-6/Ti3C2Tz MXene Nanocomposites Synthesized by in Situ Ring Opening Polymerization of ε-Caprolactam and Their Water Transport Properties
- 9 May 2019
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (22) , 20425-20436
Abstract
Clay-reinforced nylon-6 nanocomposites (NCs) - characterized by the full exfoliation of the nano-reinforcement – were introduced in the marketplace in the 1990s. Herein we demonstrate, for the first time, that Ti3C2Tz MXene can be incorporated into nylon-6 to synthesize melt-processable nanocomposites with excellent barrier properties (94% reduction in water vapor permeation). To intercalate the ε-caprolactam monomer between the MXene multilayers they were first treated with 12-aminolauric acid, a low-cost, non-toxic, biodegradable, and long shelf life compound. Upon heating to 250 °C, in the presence of 6-aminocaproic acid, in situ polymerization occurred, yielding melt-processable nylon-6/MXene NCs that were, in turn, studied by thermogravimetric analysis, differential scanning calorimetry, X-ray diffraction, scanning and transmission electron microscopy, infrared spectroscopy, and dynamic vapor sorption analysis. Using the latter, moisture-sorption isotherms of a neat and a 1.9 vol. % NC, at 60 °C, were fit to the Guggenheim, Anderson and de Boer (GAB) equation. Solubility, permeation and diffusion coefficients of water through the NCs were measured as a function of temperature and found to be the lowest ever reported for nylon-6, despite the fact that, at ≈1.9 and 5.0 vol. %, the MXene loads were relatively low. This record low diffusivity is ascribed to the very large aspect ratios – 500 to 1000 - of Ti3C2Tz flakes and their dispersion. The water permeation rate is a factor of 5 lower than the best reported in the much more mature nylon/clay field, suggesting lower values can be achieved with further optimization. Lastly infrared spectroscopy spectra of neat and NC samples suggest the surface terminations of the 12-Ti3C2Tz flakes bind with nylon-6, limiting water adsorption sites, resulting in reduced solubility of NC films.Keywords
Funding Information
- Army Research Office (69521MSII)
This publication has 42 references indexed in Scilit:
- Spectroscopic study on water diffusion in aromatic polyamide thin filmJournal of Membrane Science, 2011
- A review on polymer–layered silicate nanocompositesProgress in Polymer Science, 2008
- Water transport properties of polyamide 6 based nanocomposites prepared by melt blending: On the importance of the clay dispersion state on the water transport properties at high water activityJournal of Membrane Science, 2008
- Barrier properties of nylon 6-montmorillonite nanocomposite membranes prepared by melt blending: Influence of the clay content and dispersion stateConsequences on modellingJournal of Membrane Science, 2007
- Twenty Years of Polymer‐Clay NanocompositesMacromolecular Materials and Engineering, 2006
- Effects of Moisture Conditioning Methods on Mechanical Properties of Injection Molded Nylon 6Journal of Reinforced Plastics and Composites, 2004
- Polymer/layered silicate nanocomposites: a review from preparation to processingProgress in Polymer Science, 2003
- Crystallization behavior of nylon 6 nanocompositesPolymer, 2003
- Clustering of Water in Polymers1980
- Relationships on the effect of water on glass transition temperature and young's modulus of nylon 6Journal of Polymer Science: Polymer Chemistry Edition, 1978