Effect of Coating and Low Viscosity Oils on Piston Ring Friction under Mixed Regime of Lubrication through Analytical Modelling
Open Access
- 17 December 2021
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 9 (12) , 124
Abstract
This paper presents the impact of coating topography in piston ring-liner conjunction under mixed regime of lubrication using low viscosity oils. The study provides a time efficient analytical model including mixed-hydrodynamics regime of lubrication under different contact conditions. The method modified the expressions of the contact load and area of Greenwood-Tripp model in order to capture the real asperities interaction into contact. The model represents the tribological behavior of a thin top ring at Top Dead Centre, where boundary and mixed conditions are predominant. Electroplated CrN and PVD TiN coated rings were studied to predict the ring friction. The results are compared with an uncoated steel ring. The CrN coating shows slighter coefficient of friction, due to the coating morphology and roughness parameters. The TiN coating presents thicker lubricant films and higher coefficient of friction because the surface topography is quite rough with high peaks. This can be explained because of the major contribution of the roughness parameter and asperity slope in the boundary friction prediction.Keywords
This publication has 42 references indexed in Scilit:
- The influence of piston ring geometry and topography on frictionProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- The influence of inter-ring pressures on piston-ring/liner tribological conjunctionProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2012
- Advanced thermal spray technology and coating for lightweight engine blocks for the automotive industrySurface and Coatings Technology, 2005
- Tribological Investigation of Piston Ring Coatings Operating in an Alternative Fuel and Engine Oil BlendTribology Transactions, 2002
- Effect of reciprocating and unidirectional sliding motion on the friction and wear of copper on steelWear, 2001
- PVD CrxN coatings for tribological application on piston ringsSurface and Coatings Technology, 1997
- Application of Average Flow Model to Lubrication Between Rough Sliding SurfacesJournal of Lubrication Technology, 1979
- The Contact of Two Nominally Flat Rough SurfacesProceedings of the Institution of Mechanical Engineers, 1970
- A Dynamic Theory of Piston-Ring Lubrication : 2nd Report, ExperimentBulletin of JSME, 1960
- A Dynamic Theory of Piston-Ring Lubrication : 1st Report, CalculationBulletin of JSME, 1959