Effect of Machine Feed Rate on Kerf-Width, Material Removal Rate, and Surface Roughness in Machining of Al/SiC Composite Material with Wire Electrical Discharge Machine
Authors:
Open Access
- 1 April 2020
- journal article
- research article
- Published by Walter de Gruyter GmbH in Strojnícky časopis - Journal of Mechanical Engineering
- Vol. 70 (1) , 81-88
Abstract
The impact of machine feed rates of Wire Electric Discharge Machining on the kerf-width (K-width), material-removal-rate (MR-R), and surface-roughness (S-R) in the machining of Al/SiC composite is practically analysed. The relation among the feed rates of machine and K-width, MR-R, S-R is graphically acquired. It is demonstrated that lesser rate of feed is responsible for generation of larger K-width, lesser MR-R, and good finish as compared to more feed rate.Keywords
This publication has 16 references indexed in Scilit:
- Powder-Mixed Electro-Discharge Diamond Surface Grinding Process: Modelling, Comparative Analysis and Multi-Output Optimisation Using Weighted Principal Components AnalysisStrojniški vestnik - Journal of Mechanical Engineering, 2013
- Experimental investigation, intelligent modeling and multi-characteristics optimization of dry WEDM process of Al–SiC metal matrix compositeJournal of Manufacturing Processes, 2013
- Wire electrical discharge machining of AA7075/SiC/Al2O3 hybrid composite fabricated by inert gas-assisted electromagnetic stir-casting processJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2013
- Optimization of Electro-Discharge Diamond Surface Grinding Process Parameters with Multiple Performance Characteristics of Ti-6Al-4V Using Grey-Taguchi ApproachAdvanced Materials Research, 2012
- Investigation of wire electrical discharge machining characteristics of Al6063/SiCp compositesThe International Journal of Advanced Manufacturing Technology, 2011
- Material removal characteristics of microslot (kerf) geometry in μ-WEDM on aluminumThe International Journal of Advanced Manufacturing Technology, 2010
- A study on the performance of some multi-response optimisation methods for WEDM processesThe International Journal of Advanced Manufacturing Technology, 2009
- Study of WEDM parameter phenomena for microfabricationInternational Journal of Manufacturing Technology and Management, 2008
- Investigation of wire electrical discharge machining of thin cross-sections and compliant mechanismsInternational Journal of Machine Tools and Manufacture, 2005
- State of the art in wire electrical discharge machining (WEDM)International Journal of Machine Tools and Manufacture, 2004