Temperature‐stable Barium Titanate Ceramics Containing Niobium Pentoxide
Author:
Open Access
- 1 January 1976
- journal article
- research article
- Published by Wiley in Active and Passive Electronic Components
- Vol. 2 (4) , 241-247
Abstract
Niobium is known to lower the Curie point and broaden the permittivity peak of barium titanate. However, the distribution of niobium in sintered barium titanate is often not homogeneous, being influenced by such preparation variables as large cation/small cation stoichiometry and firing conditions. In addition to these factors, it was found that, at least up to about 5 mol% Nb, the distribution of niobium in the barium titanate grains could be regulated by small amounts (<1 mol%) of oxides of Co, Mg, Ni or Mn. These oxides appear to form niobates that produce high permittivity solid solutions in the “skins” of the barium titanate grains and permit dielectrics to be obtained with permittivity (K2000), stable to within ±10% over the temperature range −55℃ to 125℃.Keywords
This publication has 6 references indexed in Scilit:
- High resistivity BaTiO3 ceramics sintered in CO-CO2 atmospheresJournal of Materials Science, 1975
- Effects of Grain Growth on the Distribution of Nb in BaTiO 3 CeramicsJournal of the American Ceramic Society, 1971
- Influence of Grain Growth on Dielectric Properties of Nb‐Doped BaTiO3Journal of the American Ceramic Society, 1971
- Phase equilibrium relations in the binary system barium oxide-niobium pentoxideJournal of Research of the National Bureau of Standards Section A: Physics and Chemistry, 1961
- Effect of Additives of Limited Solid Solubility on Ferroelectric Properties of Barium Titanate CeramicsJournal of the American Ceramic Society, 1959
- Dielectric and Structural Studies in the Systems Ba(Ti, Nb)O 3 and Ba(Ti, Ta)O 3Journal of the American Ceramic Society, 1959