A Low-Temperature Direct-Current Comparator Bridge
Authors:
- D. B. SullivanDSD. B. Sullivan
- Ronald F. DziubaRDRonald F. Dziuba
- 1 December 1974
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 23 (4) , 256-260
Abstract
The application of superconducting direct-current comparators to the measurement of resistance ratios is described. One comparator consists of a binary set of ratios between 1:1 and 160:1 providing for self-calibration by a buildup procedure. A second comparator exhibiting discrete ratios of 1:1, 10:1, and 100:1 is also described. Ratio uncertainty of less than 1 part in 109 is achieved by enclosing the ratio windings in overlapping toroidal superconducting shields. Superconducting quantum interference devices (SQUID's) serve as flux sensors for the comparators. One of these current comparators is used to calibrate a 100-Ω:1-Ω resistive divider, which at a current of 10 mA exhibits a self-heating error of 0.0023 ppm.Keywords
This publication has 9 references indexed in Scilit:
- Low temperature direct current comparatorsReview of Scientific Instruments, 1974
- Precise resistance ratio measurements using a superconducting dc ratio transformerReview of Scientific Instruments, 1973
- A Precise Low Temperature dc Ratio TransformerReview of Scientific Instruments, 1972
- Low Temperature Voltage Divider and Null DetectorReview of Scientific Instruments, 1972
- A Mechanical Superconducting Switch for Low Temperature InstrumentationReview of Scientific Instruments, 1972
- Recent NPL Work on the AC Josephson Effect as a Voltage StandardIEEE Transactions on Instrumentation and Measurement, 1972
- Sensitivity Enhancement of Superconducting Quantum Interference Devices through the Use of Fractional-Turn LoopsJournal of Applied Physics, 1971
- Resistance of a Silicon Bronze at Low TemperaturesReview of Scientific Instruments, 1971
- Design and Operation of Stable rf-Biased Superconducting Point-Contact Quantum Devices, and a Note on the Properties of Perfectly Clean Metal ContactsJournal of Applied Physics, 1970