On-site testing and diagnosis of transmission power cables up to 230 kV using damped AC voltages
- 24 April 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electrical Insulation Magazine
- Vol. 30 (3) , 27-38
Abstract
Failures of the insulation of HV power cables can occur during operation at normal voltage or as a result of a transient voltage spike due to lightning or switching. Failures may occur if localized electrical stresses exceed the dielectric strength of the insulation or if the insulation is degraded to the point that it cannot withstand the applied voltage.Keywords
This publication has 8 references indexed in Scilit:
- Estimation of dielectric loss using damped AC voltagesIEEE Electrical Insulation Magazine, 2011
- Statistical analysis of subcomponent failures in power transformers2011
- Measurement of partial discharges as a data source supporting power cable network management2009
- Statistical approach in power cables diagnostic data analysisIEEE Transactions on Dielectrics and Electrical Insulation, 2008
- On-site testing and PD diagnosis of high voltage power cablesIEEE Transactions on Dielectrics and Electrical Insulation, 2008
- Detection of Partial Discharges at Different AC Voltage Stresses in Power CablesIEEE Electrical Insulation Magazine, 2007
- Condition assessment of high voltage power cables2005
- Ageing mechanisms and diagnostics for power cables - an overviewIEEE Electrical Insulation Magazine, 2001