Near-zero gate bouncing in high-frequency converters with shield-plate FETs
Authors:
- 1 March 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 2386-2391
Abstract
The gate bouncing of the Shield-Plate FETs (SP-FETs) in synchronous buck converters is investigated in this work for the first time. A comparative analysis between a 30V SP-FET and a 30V TP-FET (Trench Power MOSFET) working as a synchronous switch is provided by experimental results and mixed-mode simulation. Although the current conduction during the deadtime is due to different mechanisms, the extremely low Crss/Ciss ratio (<; 0.01) is identified as the main responsible for the negligible gate bouncing in SP-FETs. The gate bouncing immunity is presented as a new paradigm for the circuit/device co-design, thus allowing the reduction of the driver deadtime and the MOSFET threshold voltage in order to achieve efficiency peaks above 90% for 12V-to-1.2V conversion at 1MHz operation frequency.Keywords
This publication has 8 references indexed in Scilit:
- Body-diode related losses in Shield-Plate FETs for SiP 12V-input DC/DC buck converters operating at high-frequency (4MHz)2012
- A high-speed silicon FET for efficient DC-DC power conversion2012
- Gallium Nitride based 3D integrated non-isolated point of load module2012
- Impact of Source Inductance on Synchronous Buck Regulator FET Shoot Through Performance2007
- The impact of sub-threshold current on ultra high density trench MOSFET for synchronous rectifier application2004
- Advanced characterization of low-voltage power MOSFETs in synchronous-rectifier buck-converter applications2004
- The influence of body effect and threshold voltage reduction on trench MOSFET body diode characteristics2004
- Optimization of the body-diode of power MOSFETs for high efficiency synchronous rectification2002