Study of the Combined Effects of the Air-Gap Transfer for Maxwell Tensor and the Tooth Mechanical Modulation in Electrical Machines
- 18 December 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 56 (1) , 1-4
Abstract
The Maxwell Tensor (MT) method is widely used to compute global forces or local surface forces for vibroacoustic design of electrical machines under electromagnetic excitation. In particular, the air-gap MT method is based on a cylindrical shell in the middle of the air gap. This article proposes to quantify the differences between the air-gap MT and the magnetic force wave experienced by the stator. In particular, the air gap to stator transfer and the tooth mechanical modulation effects are studied. A new formula is proposed to extend the tooth modulation effect to tangential forces. A numerical application is performed with a turbo-alternator to illustrate the respective and combined effects of both phenomena. This article highlights that the tooth mechanical modulation is relevant even for electrical machines with a high number of teeth. In addition, the combination of the two phenomena has a clear impact on the calculated surface force. Therefore, it is recommended to take into account the air-gap transfer for any study of the tooth mechanical modulation effect.Keywords
This publication has 6 references indexed in Scilit:
- Analysis of Zeroth-Mode Slot Frequency Vibration of Integer Slot Permanent-Magnet Synchronous MotorsIEEE Transactions on Industrial Electronics, 2019
- Modulation Effect of Slotted Structure on Vibration Response in Electrical MachinesIEEE Transactions on Industrial Electronics, 2018
- Comparison of Main Magnetic Force Computation Methods for Noise and Vibration Assessment in Electrical MachinesIEEE Transactions on Magnetics, 2018
- Influence of Pole and Slot Combinations on Magnetic Forces and Vibration in Low-Speed PM Wind GeneratorsIEEE Transactions on Magnetics, 2013
- Analytical Prediction of Noise of Magnetic Origin Produced by Permanent Magnet Brushless Motors2007
- Comparison of different force calculation methods in 3D finite element modellingIEEE Transactions on Magnetics, 1994