Conducted EMI characteristic and its implications to filter design in 3-phase diode front-end converters
Authors:
- 8 November 2004
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3 (01972618) , 1840-1846
Abstract
EMI filter is becoming an essential part for modern power converter products, contributing to significant cost and sizes. Effective EMI filter design involves the identification and separation of common-mode (CM) and differential-mode (DM) conducted noises of the converter. In this paper, the impact by the diode conduction patterns on the EMI characteristics of a three-phase diode front-end converter is analyzed. There are classical two-line CM and DM noises similar to single phase cases corresponding to the two diode conducting case, the "mixed-mode" CM noise corresponding to no diodes conducting cases, and the three-line CM and DM noise corresponding to commutation cases. Though the present filter design based on single-phase approach seems to be adequate as a worst-case design, a more generic approach considering all three conditions together may provide opportunities for filter design optimization.Keywords
This publication has 10 references indexed in Scilit:
- Optimizing EMI filter design for motor drives considering filter component high-frequency characteristics and noise source impedance2004
- Experimental evaluation of IGBTs for characterizing and modeling conducted EMI emission in PWM inverters2004
- A novel differential mode rejection network for conducted emissions diagnostics2003
- Common mode disturbance reduction of PFC full bridge rectifiers2002
- Mixed-mode EMI noise and its implications to filter design in offline switching power suppliesIEEE Transactions on Power Electronics, 2002
- Measurement of conducted electromagnetic emissions in PWM motor drive systems without the need for an LISNIEEE Transactions on Electromagnetic Compatibility, 1999
- Conducted electromagnetic emissions in induction motor drive systems. II. Frequency domain modelsIEEE Transactions on Power Electronics, 1998
- Separation of the common-mode- and differential-mode-conducted EMI noiseIEEE Transactions on Power Electronics, 1996
- A procedure for designing EMI filters for AC line applicationsIEEE Transactions on Power Electronics, 1996
- Diagnosis and reduction of conducted noise emissionsIEEE Transactions on Electromagnetic Compatibility, 1988