Injection molding of ceramic filled polypropylene: The effect of thermal conductivity and cooling rate on crystallinity
Open Access
- 1 December 2013
- journal article
- Published by Elsevier in Thermochimica Acta
- Vol. 574, 145-150
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Mechanical and thermal properties of composites of cis and trans-polyisoprene blends filled with Al-powderPowder Technology, 2012
- Thermal conductivity of carbon nanotubes and their polymer nanocomposites: A reviewProgress in Polymer Science, 2011
- The effects of particle size and content on the thermal conductivity and mechanical properties of Al2O3/high density polyethylene (HDPE) compositesExpress Polymer Letters, 2011
- Crystalline structure of annealed polylactic acid and its relation to processingExpress Polymer Letters, 2010
- Effect of thermal conductivity and heat transfer on crystallization, structure, and morphology of polypropylene containing different fillersJournal of Applied Polymer Science, 2004
- Heat transfer with mechanically driven thermal contact resistance at the polymer–mold interface in injection molding of polymersInternational Journal of Heat and Mass Transfer, 2004
- The surface science of titanium dioxideSurface Science Reports, 2003
- The measurement of the crystallinity of polymers by DSCPolymer, 2002
- The calculation of cooling time in injection mouldingJournal of Materials Processing Technology, 1996
- Thermal contact resistance in injection moldingPolymer Engineering & Science, 1990