Numerical Investigation of the Punching Resistance of Reinforced Concrete Flat Plates
- 1 October 2018
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 144 (10)
Abstract
Nonlinear finite-element analyses are used to numerically investigate the punching shear resistance of reinforced concrete flat plate structures. Material nonlinearity is based principally on the formulations of the disturbed stress field model, a smeared crack reinforced concrete modeling procedure. Low-cost three-dimensional solid finite elements and one-dimensional truss bar finite elements are used to represent concrete and steel reinforcement, respectively. Requiring only easily defined concrete material properties and employing fundamental finite-element meshing techniques, the modeling approach was found to provide good response estimates for slab–column connection assembly tests under concentric shear loading conditions and was shown to effectively capture the effects of design parameters on slab punching shear performance: reinforcement ratio, column size, and slab thickness. The validated modeling approach was used to perform a brief numerical investigation on the effects of boundary conditions on the punching shear capacity of multibay flat plates. The results from the investigation were compared to the response obtained for an equivalent isolated slab–column assembly specimen and to existing code provisions and two-way shear analysis procedures.Keywords
This publication has 22 references indexed in Scilit:
- Capturing Out-of-Plane Shear Failures in the Analysis of Reinforced Concrete ShellsJournal of Structural Engineering, 2015
- Finite element analysis of punching shear of concrete slabs using damaged plasticity model in ABAQUSEngineering Structures, 2015
- Application of damage–plasticity models in finite element analysis of punching shearComputers & Structures, 2015
- Influence of moment redistribution and compressive membrane action on punching strength of flat slabsEngineering Structures, 2015
- Punching shear failure of slab with lightweight aggregate concrete (LWAC) and low reinforcement ratioConstruction and Building Materials, 2014
- Modelling and experimental assessment of punching shear in flat slabs with shearheadsEngineering Structures, 2010
- Disturbed Stress Field Model for Reinforced Concrete: FormulationJournal of Structural Engineering, 2000
- Toward Compression‐Field Analysis of Reinforced Concrete SolidsJournal of Structural Engineering, 1991
- Membrane action in reinforced concrete slabsCanadian Journal of Civil Engineering, 1990
- Preventing Progressive Collapse of Slab StructuresJournal of Structural Engineering, 1984