Re-Evaluating the Stability of Al2O3 Barriers Prepared by Atomic Layer Deposition under Electrochemical Conditions
Open Access
- 19 August 2025
- journal article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (34) , 48320-48333
Abstract
Atomic layer-deposited (ALD) films are widely used as insulating barriers in (photo)electrochemical systems, yet their stability and charge-transfer behavior under operational conditions remain poorly characterized. Here, we systematically investigate how film thickness and electrolyte composition influence the performance of ALD-grown amorphous Al2O3 films on indium tin oxide. Using cyclic voltammetry and electrochemical impedance spectroscopy, we find that a thickness of ∼4-5 nm is required to achieve stable insulation and tunneling-limited electron transfer, which is significantly more than the minimum needed to form a continuous film. Moreover, the extracted tunneling decay constant, 0.30 Å-1, is lower than values reported for crystalline Al2O3, indicating noticeable charge transport through amorphous thin films. On the other hand, a reduction in the effective diffusion of redox active molecules at the electrode surface is suggested for films thicker than 3 nm. We further demonstrate that specific ions strongly influence film lifetime. Unexpectedly, we found that acetate buffers are significantly less detrimental to film stability compared to commonly used phosphate buffers. Moreover, the addition of low concentrations of Al3+ ions dramatically delays film degradation. In contrast, pH effects between 4 and 8 are minimal. Notably, film failure shows stochastic behavior while also being broadly consistent with gradual homogeneous dissolution rather than discrete pinhole formation previously reported for TiO2 and Al2O3 insulating films. These results reveal the critical and previously underappreciated role of electrolyte composition in determining the lifetime of insulating oxide films. Our findings offer practical design guidelines and highlight the need for controlled conditions when implementing ALD barriers in electrochemical devices.Keywords
Funding Information
- Carl Tryggers Stiftelse f?r Vetenskaplig Forskning (22:2062)
This publication has 60 references indexed in Scilit:
- Al2O3 Underlayer Prepared by Atomic Layer Deposition for Efficient Perovskite Solar CellsChemSusChem, 2017
- Room‐Temperature Atomic Layer Deposition of Al2O3: Impact on Efficiency, Stability and Surface Properties in Perovskite Solar CellsChemSusChem, 2016
- Physics of Semiconductor Devices2015
- Dependence of the capacitance between an electrode and an electrolyte solution on the thickness of aluminum oxide layers deposited using atomic layer depositionJournal of Electroanalytical Chemistry, 2013
- Marcus–Hush–Chidsey theory of electron transfer applied to voltammetry: A reviewElectrochimica Acta, 2012
- Failure mechanism of thin Al2O3 coatings grown by atomic layer deposition for corrosion protection of carbon steelElectrochimica Acta, 2011
- Electrochemistry of redox-active self-assembled monolayersCoordination Chemistry Reviews, 2010
- On the mechanism of the passivity of aluminum and aluminum alloysJournal of Electroanalytical Chemistry, 1993
- Electrochemistry of Aluminum in Aqueous Solutions and Physics of Its Anodic Oxide1989
- The hydration of barrier oxide films on aluminium and its inhibition by chromate and phosphate ionsCorrosion Science, 1982