New Mold Slag Compositions for the Continuous Casting of Soft Steels
Open Access
- 24 May 2021
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 93 (3) , 2100165
Abstract
Several fluorine‐free mold slag compositions have already been established in the literature. In all cases, the formation of a crystalline phase exhibiting behavior similar to that of cuspidine is emphasized to control horizontal heat transfer without influencing the lubrication performance for the casting of peritectic steel grades. In contrast, for casting soft steels, glassy solidification of the slag is required. Herein, different slag compositions involving the selected oxides are developed with the help of FactSage calculations. Mixtures of pure raw materials are melted at 1673 K and quenched to 295 K. It is observed that B2O3 increases the glass‐forming ability of the slags. To obtain the glassy phase, the composition must satisfy the conditions and . For TiO2 content 15 wt%. Moreover, the addition of alumina and alkali oxides enhances crystallization. Based on these findings, promising mold slag compositions are designed and characterized in the laboratory using a furnace crystallization test, mineralogical investigations, and the single/double hot thermocouple technique. From the investigated mixtures, three compositions are suggested for use in continuous casting processes.Keywords
This publication has 30 references indexed in Scilit:
- Assessment of CaO^|^ndash;Al2O3 Based Mold Flux System for High Aluminum TRIP CastingISIJ International, 2013
- Fluorine‐Free Mould Powders for Billet Casting – Technological Parameters and Industrial TestsSteel Research International, 2012
- Solidification Properties of CaO-SO2-TiO2 Based Mold FluxesJournal of Iron and Steel Research International, 2011
- Single hot thermocouple technique for the characterization of the crystallization behavior of transparent or translucent liquidsJournal of Materials Science, 2011
- Viscosity and Viscosity Estimate Model of Fluoride-Free and Titanium-Bearing Mold FluxesJournal of Iron and Steel Research International, 2010
- A Study on the Effect of Na2O on the Viscosity for Ironmaking SlagsSteel Research International, 2010
- Investigation on heat transfer performance of fluoride-free and titanium-bearing mold fluxesJournal of Non-Crystalline Solids, 2008
- Development of Fluoride-free Mold Powders for Peritectic Steel Slab CastingISIJ International, 2007
- Crystallization of CaO–SiO2–TiO2 Slag as a Candidate for Fluorine Free Mold FluxISIJ International, 2006
- Development of Fluoride-Free Fluxes for Billet CastingISIJ International, 2005