Force Application During Handcycling and Handrim Wheelchair Propulsion: An Initial Comparison
- 1 December 2013
- journal article
- research article
- Published by Human Kinetics in Journal of Applied Biomechanics
- Vol. 29 (6) , 687-695
Abstract
The aim of the study was to evaluate the external applied forces, the effectiveness of force application and the net shoulder moments of handcycling in comparison with handrim wheelchair propulsion at different inclines. Ten able-bodied men performed standardized exercises on a treadmill at inclines of 1%, 2.5% and 4% with an instrumented handbike and wheelchair that measured three-dimensional propulsion forces. The results showed that during handcycling significantly lower mean forces were applied at inclines of 2.5% (P < .001) and 4% (P < .001) and significantly lower peak forces were applied at all inclines (1%: P = .014, 2.5% and 4%: P < .001). At the 2.5% incline, where power output was the same for both devices, total forces (mean over trial) of 22.8 N and 27.5 N and peak forces of 40.1 N and 106.9 N were measured for handbike and wheelchair propulsion. The force effectiveness did not differ between the devices (P = .757); however, the effectiveness did increase with higher inclines during handcycling whereas it stayed constant over all inclines for wheelchair propulsion. The resulting peak net shoulder moments were lower for handcycling compared with wheelchair propulsion at all inclines (P < .001). These results confirm the assumption that handcycling is physically less straining.Keywords
This publication has 36 references indexed in Scilit:
- Effects of 4-weeks of asynchronous hand-rim wheelchair practice on mechanical efficiency and timingDisability and Rehabilitation, 2010
- Chronic pain in individuals with spinal cord injury: a survey and longitudinal studySpinal Cord, 2005
- A Physiological Comparison of Synchronous and Asynchronous Hand CyclingInternational Journal of Sports Medicine, 2004
- Alternative Modes of Manual Wheelchair AmbulationAmerican Journal of Physical Medicine & Rehabilitation, 2001
- The position of the rotation center of the glenohumeral jointJournal of Biomechanics, 2000
- Handcycling: different modes and gear ratiosJournal of Medical Engineering & Technology, 2000
- The effect of wheelchair handrim tube diameter on propulsion efficiency and force application (tube diameter and efficiency in wheelchairs)IEEE Transactions on Rehabilitation Engineering, 1996
- Upper limb function in persons with long term paraplegia and implications for independence: Part ISpinal Cord, 1994
- Load on the upper extremity in manual wheelchair propulsionJournal of Electromyography and Kinesiology, 1991
- Wheelchair ergonomics and physiological testing of prototypesErgonomics, 1986