Improvement in Fatigue Strength of Chromium–Nickel Austenitic Stainless Steels via Diamond Burnishing and Subsequent Low-Temperature Gas Nitriding
Open Access
- 25 January 2024
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 14 (3) , 1020
Abstract
Chromium–nickel austenitic stainless steels are widely used due to their high corrosion resistance, good weldability and deformability. To some extent, their application is limited by their mechanical characteristics. As a result of their austenitic structure, increasing the static and dynamic strength of the components can be achieved by surface cold work. Due to the tendency of these steels to undergo intercrystalline corrosion, another approach to improving their mechanical characteristics is the use of low-temperature thermo-chemical diffusion processes. This article proposes a new combined process based on sequentially applied diamond burnishing (DB) and low-temperature gas nitriding (LTGN) to optimally improve the fatigue strength of 304 steel. The essence of the proposed approach is to combine the advantages of the two processes (DB and LTGN) to create a zone of residual compressive stresses in the surface and subsurface layers—the enormous surface residual stresses (axial and hoop) introduced by LTGN, with the significant depth of the compressive zone characteristic of static surface cold working processes. DB (both smoothing and single-pass hardening), in combination with LTGN, achieves a fatigue limit of 600 MPa, an improvement of 36.4% compared to untreated specimens. Individually, smoothing DB, single-pass DB and LTGN achieve 540 MPa, 580 MPa and 580 MPa, respectively. It was found that as the degree of plastic deformation of the surface layer introduced by DB increases, the content of the S-phase in the nitrogen-rich layer formed by LTGN decreases, with a resultant increased content of the ε-phase and a new (also hard) phase: stabilized nitrogen-bearing martensite.Keywords
All Related Versions
Funding Information
- European Regional Development Fund within the OP (BG05M2OP001-1.002-0023)
This publication has 41 references indexed in Scilit:
- The effect of surface mechanical attrition treatment on low temperature plasma nitriding of an austenitic stainless steelSurface and Coatings Technology, 2013
- Comparison of Roller Burnishing Method with Other Hole Surface Finishing Processes Applied on AISI 304 Austenitic Stainless SteelJournal of Materials Engineering and Performance, 2010
- Plasma nitriding of 316L austenitic stainless steel: Experimental investigation of fatigue life and surface evolutionSurface and Coatings Technology, 2010
- Fatigue behaviour of low temperature carburised AISI 316L austenitic stainless steelSurface and Coatings Technology, 2008
- Residual stress relaxation of deep-rolled austenitic steelScripta Materialia, 2008
- Comparison of the fatigue behavior and residual stress stability of laser-shock peened and deep rolled austenitic stainless steel AISI 304 in the temperature range 25–600°CMaterials Science and Engineering: A, 2007
- Surface nanocrystallization by surface mechanical attrition treatment and its effect on structure and properties of plasma nitrided AISI 321 stainless steelActa Materialia, 2006
- High temperature fatigue behavior and residual stress stability of laser-shock peened and deep rolled austenitic steel AISI 304Scripta Materialia, 2004
- Cyclic deformation and near surface microstructures of shot peened or deep rolled austenitic stainless steel AISI 304Materials Science and Engineering: A, 1999
- Ball burnishing of 316L stainless steelJournal of Materials Processing Technology, 1993