Evaluation of System Identification Methods for Free Vibration Flutter Derivatives of Long-Span Bridges
Open Access
- 7 April 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (8) , 4672
Abstract
The significance of long-span bridges being susceptible to wind-induced vibrations and the need for evaluating their aerodynamic performance is the focus of this study. The main emphasis is on experimental methods for assessing the bridges’ aerodynamic stability, using sectional model tests with the free vibration technique. The dynamic properties of the model are determined from the measured response, using various system identification methods, including the modified Ibrahim time domain (MITD) and iterative least squares (ILS) for two-degree-of-freedom systems and the logarithmic decrement method (LDM) and the Hilbert transform method (HTM) for single-degree-of-freedom (SDOF) systems. A new dynamic testing setup was designed to facilitate single-degree-of-freedom (heave and pitch) and coupled two-degree-of-freedom (2DOF) motion in a wind tunnel section model. The vertical and torsional stiffnesses of the model were adjusted with elastic springs. A Great Belt Bridge section model was selected for testing due to its streamlined aerodynamic shape. The direct and crossflow derivatives were extracted from the measured response using the system identification methods mentioned. Additionally, analytical studies and numerical computational fluid dynamics simulations were conducted to validate the experimental results. The study found that HTM is most effective in SDOF due to its ability to extract both damping and frequency from the nonlinear response, whereas the MITD method is faster in converging system parameters in 2DOF system tests. The experimental and numerical results are comparable to the flat plate, which confirms the streamlined behavior of the Great Belt section from an aerodynamic perspective.Keywords
This publication has 33 references indexed in Scilit:
- Vibration Mechanisms and Controls of Long-Span Bridges: A ReviewStructural Engineering International, 2013
- Frequency and damping adaptation of a TMD with controlled MR damperSmart Materials and Structures, 2012
- Computational models and methods for aerodynamic flutter of long-span bridgesJournal of Wind Engineering and Industrial Aerodynamics, 2008
- Flutter and buffeting performances of Third Nanjing Bridge over Yangtze River under yaw wind via aeroelastic model testJournal of Wind Engineering and Industrial Aerodynamics, 2007
- A new technique for identification of eighteen flutter derivatives using a three-degree-of-freedom section modelEngineering Structures, 2003
- Simultaneous pressures and accelerations measured full-scale on the Great Belt East suspension bridgeJournal of Wind Engineering and Industrial Aerodynamics, 2001
- Reduction of vortex-induced oscillations of Rio–Niterói bridge by dynamic control devicesJournal of Wind Engineering and Industrial Aerodynamics, 2000
- Discrete vortex simulation of flow around five generic bridge deck sectionsJournal of Wind Engineering and Industrial Aerodynamics, 1998
- Identification of Aeroelastic Parameters of Flexible BridgesJournal of Engineering Mechanics, 1994
- Aerodynamic aspects of the final design of the 1624 m suspension bridge across the Great BeltJournal of Wind Engineering and Industrial Aerodynamics, 1993