On the Reflectivity Extraction Based on Partial Bistatic Near-Field Scattering From Microwave Blackbody
- 31 August 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 69 (3) , 1692-1705
Abstract
This work reports numerical investigations on the scattering from microwave blackbody, for developing a national standard facility on the emissivity determination in China. Based on the Kirchhoff’s law of thermal equilibrium, the standard facility follows a bistatic scattering measurement configuration and covers a wide frequency range. In general, the reflectivity is to be extracted based on partially collected scattering in the near-field region. The whole electromagnetic process, from the quasi-optical antenna illumination, to target scattering, and finally the aperture coupling reception, is modeled to be analyzed. It is shown in the simulation results that the Floquet scattering properties of the array-shaped blackbody can be obtained without fulfilling the far-field condition. Then, evaluations on the reflectivity extraction are performed at 54, 89, 118, and 183 GHz, addressing typical blackbody structures of coated cones and coated pyramids. The factors of referencing targets, curve integration, and the oblique incidence are discussed, as well as the case of geometry flawed blackbody. This work offers important reference and specific suggestions for achieving accurate and stable reflectivity determination in the bistatic near-field configuration.Keywords
Funding Information
- Beijing University of Chemical Technology (buctrc201931)
- National Natural Science Foundation of China (61671032,61701496)
- Shanghai Academy of Spaceflight Technology (SAST2017-109)
- the National Key Research and Development Program (2017YFF020503)
This publication has 20 references indexed in Scilit:
- Design, Manufacturing, and Characterization of Conical Blackbody Targets With Optimized ProfileIEEE Transactions on Terahertz Science and Technology, 2017
- Electromagnetic Design of Calibration Targets for MetOp-SG Microwave InstrumentsIEEE Transactions on Terahertz Science and Technology, 2017
- Brightness Temperature Computation of Microwave Calibration TargetsIEEE Transactions on Geoscience and Remote Sensing, 2017
- Effects of Coating Material Properties on the Wideband Reflectivity Performance of Microwave Calibration TargetsIEEE Transactions on Antennas and Propagation, 2017
- ANALYSIS ON THE FLOQUET SCATTERING LOBES FROM MICROWAVE CALIBRATION TARGETSProgress In Electromagnetics Research B, 2017
- On the Coiflet-TDS Solution for Scattering by Sharp Coated Cones and Its Application to Emissivity DeterminationIEEE Transactions on Geoscience and Remote Sensing, 2015
- SIMULATION ANALYSIS OF THE EFFECT OF MEASURED PARAMETERS ON THE EMISSIVITY ESTIMATION OF CALIBRATION LOAD IN BISTATIC REFLECTION MEASUREMENTProgress In Electromagnetics Research, 2012
- The FengYun-3 Microwave Radiation Imager On-Orbit VerificationIEEE Transactions on Geoscience and Remote Sensing, 2011
- Proposed Development of a National Standard for Microwave Brightness Temperature2006
- WindSat on-orbit warm load calibrationIEEE Transactions on Geoscience and Remote Sensing, 2006